Craig CMA3581-OD User manual



1
FCCINFORMATION:
ThisequipmenthasbeentestedandnofoundtocomplywiththelimitsforaClassBdigital
device,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovide
reasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.This
equipmentgenerates,usesandcanradiateradiofrequencyenergyand,ifnotusedthese
instructions,maycauseharmfulinterferencetoradiocommunications.However,thereisno
guaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoes
causeharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedby
turningtheequipmentofandon,theuserisencouragedtotrytocorrecttheinterferenceby
oneormoreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connecttheequipmentintoanoutletoncircuitdifferentfromthattowhichthe
receiverisconnected.
Consultthedealeroranexperiencedradioradio/TVtechnicianforhelp.

FCCWARNING:
Thisequipmentmaygenerateoruseradiofrequencyenergy.Changesormodificationsto
thisequipmentmaycauseharmfulinterferenceunlessthemodificationsareexpressly
approvedintheinstructionmanual.Modificationsnotauthorizedbythemanufacturermay
voidusersauthoritytooperatethisdevice.

Note:
Referallservicingtoqualifiedservicepersonnel.Servicingisrequiredwhentheunithas
beendamagedanywaysuchasthefollowing:thepower‐supplycordorplughasbeen
damaged,liquidhasbeenspilledintotheunit,theunithasbeenexposedtorainor
moisture,theunithasbeendroppedortheunitdoesnotoperatenormally. 
1. Theapparatusshallnotbeexposedtodrippingorsplashingandthatnoobjectsfilled
withliquid,suchasvases,shallbeplaceontheapparatus.
2. WheretheMAINSplugoranappliancecouplerisusedasthedisconnectdevice,the
disconnectdeviceshallreailyoperable.



2
BatteryRecharge
TheunithasabuiltinLi‐ionrechargeablebattery,rechargeitbeforeuseasfollow:
ConnecttheMircoUSBplugfromtheUSBConnectionCabletotheMicroUSBPorton
therearofunit.
ConnectthefullsizeUSBplugtotheUSBportonacomputeroranyUSBchargerhavingDC
5Voutput.(Duringcharging,theRedIndicatorwillilluminate.Whenfinished,itwill
turnedoff).

Notes:
Yourbatterywilllastlongerifyoufollowingthesesimpleguidelinesforchargingand
storing.
A. Rechargingandstoretheunitwithinthetemperaturerangeof5°C~35°C(40°F~95°F).
B. Donotovercharge(longerthan24hours).Excessivechargingorrunningtheunituntil
batterygoesemptywilldamagebattery. 
C. Batterylifenaturallyshortensslowlyovertime.
D. Therechargeablebatteryincorporatedinthisproductisnotuserreplaceable.

LocationofControls:

1. Button
2. Button
3. Button
4. Button
5. Indicators
6. Built‐inMicrophone
7. MicroUSBPort(Forchargeonly)
8. USBPort
9. TF(SD)CardSlot
10. AUX(in)Jack
11. ResetButton(InsidetheAUXinJack)

3
OPERATON:

Generaloperation:
1. Pressandholdthe  Buttonapproximate0.5secondtoturniton. 
2. Pressthe  Buttonrepeatedlyuntilthedesiredmodehearingfromspeakeras
below:
Bluetoothreadyforconnection
Bluetoothconnected
Radio
Linein(=Auxin)
USB
MemoryCard 
3. PressandholdtheorButtontoadjustvolumelevel.
4. InBT;TF(SD)CardandUSBDeviceplaybackmode:
PressandreleasetheorButtonrepeatedlytoskiptracks.
Presstthe  Buttontopause;pressagaintoresumenormalplayback.
5. Whenfinishedlistening,pressandholdthe  Buttontoshutoff.


BT(Bluetooth)mode
ThefirsttimeyouusethespeakerorpairittoanewBluetoothdevice,pleasefollow
theseinstruction:
1. Powerontheunitaspreviousprocedures.
2. Pressthe  Buttonrepeatedlyuntil“Bluetoothreadyforconnection”hearfrom
speaker.TheBlueIndicatorwilllightandblinking.
3. PowerontheexternalBluetoothDeviceandentersearchingmode.Startparing
followingtheonscreeninstructionsfromtheexternalBluetoothdevice.Afterpairing,
“Bluetoothconnected”willhearfromspeakerandtheBlueIndicatorwillstopblinking.
Notes:
WhentheexternalBTplayersearchedtheunit,ourmodelnumber“CMA3581”will
appearonthedisplayoftheexternalBluetoothDevice.
Pairingcode“0000”mayneedtoenter.


Normaloperationafterpairing:
1. Powerontheunitaspreviousprocedures.
2. Pressthe  Buttonrepeatedlyuntil“Bluetoothreadyforconnection”hearfrom
speaker.Waitafewseconduntil“Bluetoothconnected”hearfromspeakerand 
theBlueIndicatorstopblinking.
3. PlaysthemusicintheconnectedBluetoothDeviceasusual.

4
Radio:
1. Powerontheunitaspreviousprocedures.Pressthe  Buttonrepeatedlyunit
“Radio”hearfromthespeaker. 
2. PresstheButtontosearchingandstoredtheavailableFMstations.During
searching,theBlueIndicatorwillblink.Whenfinishedsearching,theBlueIndicatorwill
stopblinking.
3. PressandreleasetheorButtonrepeatedlytplaystheprevious/nextavailableFM
station.
FMAntenna:
TheFMAntennaisbuiltintheunit.Ifreceptionisweak,relocationorredirectiontheunittoimprove
theradioreception



USBDeviceplaybackmode:
1. Inpoweroffmode,inserttheUSBDeviceintotheUSBPortontherearofunitasthe
figurebelow:

2. Powerontheunitaspreviousprocedures.Pressthe  Buttonrepeatedlyunit“USB” 
hearfromspeaker.TheunitwillstartplaybackthemusicontheUSBDevice
automatically.



TF(SD)Cardplaybackmode:
1. Inpoweroffmode,inserttheTF(MicroSD)CardintotheTF(MicroSD)CardSloton
therearofunitasthefigurebelow:

2. Powerontheunitaspreviousprocedures.Pressthe  Buttonrepeatedlyunit
“Memorycard”hearfromspeaker.TheunitwillstartplaybackthemusicontheTF
(MicroSD)Cardautomatically.


NOTES:
Upto16GBUSBDevice(notincluded)orTF(MicroSD)Card(notincluded)theunit
supporttoplay.

5
BeforereplacingUSBDeviceorTF(MicroSD)Card,makesuretheunithasbeen
poweredoff.
WheninsertingtheUSBDeviceorTF(MicroSD)Card,makesurethedirectionyou
selectediscorrect.NeverinsertviolentlytoavoiddamagingtheUSBDeviceortheunit.
Ifitdoesn’twork,pleasecheckifthedirectioniscorrect.
YoualsoneedtodownloadthedesiredmusicinMP3formatintotheUSBDevice
and/orTF(SD)Cardbeforeinstallingintotheunit.



AUXIN:
TolisteningfromtheexternalAudioplayerssuchlikeMP3Player,Discman…etc.
1. Inpoweroffmode,connectthe3.5mmstereojackfromthesuppliedAudioConnection
CabletotheAUXOut/LineOut/PhoneJackontheexternalAudioPlayer. 
2. ConnecttheotherendtotheAUX(in)Jackontherearofunitasthefigurebelow:

3. Powerontheunitaspreviousprocedures.Pressthe Buttonrepeatedlyunit“Line
in”hearfromspeaker.
4. PlaysthemusicontheconnectedAudioPlayerasusual.(Makesurethevolumelevelofthe
connectedAudioPlayerishighlevel.Otherwise,soundfromthisunitisweak).


RESET:
Iftheunitishaltorabnormaloperation,presstheResetButtonintheAUX(in)Jackby
asmalldriver(notincluded)toshutitoff.PressandholdtheButtonapproximate
0.5secondtoturnitonagain.
















6





Troubleshoothing:
Can’tpoweronBuiltinbatteryconsumed Rechargethebattery
NosoundorsoundweakVolumeoftheunitwassetto
minimumposition
Increasethevolumebypress
andholdtheButton
Volumeofpaired/connected
deviceinlowlevel
Risethevolumelevelofthe
connected/paireddevice
SounddistortionVolumeleveltoohigh Reducethevolumelevelby
pressandholdtheButton
Volumelevelofthe
connected/paireddevicetoo
high
Reducethevolumelevelof
theconnected/paireddevice
EQoftheconnected/paired
devicewassettosuperbass
SettheEQofthe
connected/paireddeviceto
othersmodes
BTnotfunctioning TheexternalBTdevicetoo
farfromtheunit
PlacetheexternalBTdevice
closetotheunit
TheUSBDevice/MicroSD    TheUSBDevice/MicroSDcard  TrytheothersUSB
Cardcan’tbeplaymaynotmatchthespeakerDevice/MicroSDCard


GernalSpecification:
PowerSourceBuil
t
‐inDC(DCicon)3.7V,1200mAH
(4.44WH)Li‐ionrechargablebattery;
RechargebyDC 5VthroughMicroUSB
port
MaximumPlaytimeafterfullychargeApproximate4Hoursat50%VolumeLevel
BTEffectiverange Upto32feetinopenarea
AudioPowerTotal3.6W;1.8W(RMS)perchannel; 
Impedanceofspeaker3W;4Ohmx2


Accessories:
1xUser’sManual
1xUSBConnectionCable(Forchargeonly)
1xAudioConectionCablewith3.5mmstereominiplugs



SPECIFICATIONSANDACCESSRIESARESUBJECTTOCHANGEWITHOUTNOTICE.




7


8
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body