Philips BT6700 User manual

BT6700
Register your product and get support at
www.philips.com/support
User manual

1EN
Contents
1 Important 1
Safety 1
Notice 1
2 Your Bluetooth speaker 2
Introduction 2
What's in the box 3
Overview of the speaker 3
3 Get started 4
Charge the built-in battery 4
Turn on/o 4
4 Use Bluetooth devices 5
Connect a Bluetooth device 5
Connect two Bluetooth devices
simultaneously 5
Play from Bluetooth device 6
Disconnect a device 6
Reconnect a device 6
Clear pairing information 6
Control your phone call 6
5 Other features 7
Listen to an external device 7
Adjust volume 7
6 Specications 8
7 Troubleshooting 8
General 8
About Bluetooth device 9

1EN
1 Important
Safety
Warning
•Never remove the casing of this speaker.
•Never place this speaker on other electrical
equipment.
•Keep this speaker away from direct
sunlight, naked ames or heat.
• Only use attachments or
accessories specied by the
manufacturer.
• After use under humid
circumstance, immediately clean
the product with a soft dry cloth.
• The battery shall not be exposed
to excessive heat such as sunshine,
re or the like.
• Do not place any sources of
danger on the speaker (e.g. lighted
candles).
Note
• The type plate is located on the bottom
of the speaker.
Notice
Any changes or modications made
to this device that are not expressly
approved by Gibson Innovations may
void the user’s authority to operate the
equipment.
Compliance
Hereby, Gibson Innovations declares that
this product is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC. You
can nd the Declaration of Conformity on
www.philips.com/support.
Care of the environment
Disposal of your old product and
battery
Your product is designed and
manufactured with high quality
materials and components, which can
be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
This symbol means that the product
contains a built-in rechargeable
battery covered by European Directive
2013/56/EU which cannot be disposed
of with normal household waste. We
strongly advise you to take your product
to an ocial collection point or a Philips
service centre to have a professional
remove the rechargeable battery.

2EN
Inform yourself about the local separate
collection system for electrical and
electronic products and rechargeable
batteries. Follow local rules and
never dispose of the product and
rechargeable batteries with normal
household waste. Correct disposal of
old products and rechargeable batteries
helps prevent negative consequences
for the environment and human health.
Caution
•Removal of the built-in battery invalidates
the warranty and may destroy the product.
Always bring your product to a
professional to remove the built-in
battery.
Environmental information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buer) and polyethylene (bags,
protective foam sheet.)
Your system consists of materials
which can be recycled and reused if
disassembled by a specialized company.
Please observe the local regulations
regarding the disposal of packaging
materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos
are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such
marks by Gibson Innovations Limited
is under license. Other trademarks
and trade names are those of their
respective owners.
2 Your
Bluetooth
speaker
Congratulations on your purchase, and
welcome to Philips! To fully benet from
the support that Philips oers, register
your product at www.philips.com/
welcome.
Introduction
This speaker has passed splash-proof
test (IPX4) and can be used near water.
With this speaker, you can enjoy audio
from Bluetooth-enabled devices or
other external devices.

3EN
What's in the box
Check and identify the contents of your
package:
• Speaker
• USB cable for charging
• Printed materials
Quick Start Guide
Overview of the speaker
1 2
3
4
a
• Charge the built-in battery.
b AUDIO IN
• Connect an external audio
device.
c Volume knob ( )
• Turn the speaker on or o.
• Adjust volume.
d
• Enter Bluetooth pairing mode.
• After Bluetooth connection,
respond to an incoming call.
• Clear Bluetooth pairing
information.

4EN
3 Get started
Always follow the instructions in this
chapter in sequence.
Charge the built-in
battery
The speaker is powered by the built-in
rechargeable battery.
Note
•It takes you approximately four hours to
fully charge the battery.
•Rechargeable battery has a limited number
of charge cycles. Battery life and number of
charge cycles vary by use and settings.
•When the battery is low, the LED indicator
ashes red for ten minutes, and then turns
o.
To recharge the built-in battery:
• Connect the speaker to AC power
by using the adaptor (not supplied).
System
status
Battery status LED status
On Low power Flashing
red for 10
minutes, then
turn o
On Under
charging
Solid red for 5
seconds, then
turn o
O Under
charging
Solid red
O Fully charged Turn o
Turn on/o
To turn the speaker on or o, rotate the
knob clockwise or anticlockwise until
you hear a click.
» When the speaker is turned on, the
blue LED indicator ashes.
» When the speaker is turned o, the
blue LED indicator lights o.
Note
•The speaker turns o automatically when
being idle for 15 minutes.
OFF
ON

5EN
4 Use
Bluetooth
devices
With this speaker, you can listen to
audio from Bluetooth-enabled devices
and control the incoming call through
Bluetooth.
Connect a Bluetooth
device
Note
•Make sure that Bluetooth function is
enabled on your device, and your device is
set as visible to all other Bluetooth devices.
•Any obstacle between this speaker
and a Bluetooth device can reduce the
operational range.
•Keep away from any other electronic
device that may cause interference.
•The operational range between this
speaker and a Bluetooth device is
approximately 10 meters.
1 Turn on the speaker.
» The blue LED indicator ashes.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth
devices that can be paired (see the
user manual of the device).
3 Select [Philips BT6700] displayed
on your device for pairing. If
necessary, input “0000” as the
pairing password.
» After successful connection, the
speaker beeps twice, and the
Bluetooth indicator turns solid
blue.
Connect two Bluetooth
devices simultaneously
You can pair and connect a maximum
of two Bluetooth-enabled devices to
the speaker at the same time.
• If the speaker is already connected
to one device, press and hold for
two seconds to enter pairing mode.
» The Bluetooth indicator ashes
blue quickly.
» The speaker is ready to pair with
a new Bluetooth device.
» The previous device is
disconnected with the speaker.
You need select [Philips
BT6700] for reconnection.
• If the speaker is connected to two
devices at the same time, press
and hold for two seconds to enter
pairing mode.
» The two Bluetooth devices are
disconnected, and the speaker is
ready for pairing.
Bluetooth indicator Description
Flashing blue
quickly
Ready for pairing
Flashing blue
slowly
Connecting
the previously
connected device
Solid blue Connected

6EN
Play from Bluetooth
device
Note
•Music play pauses when there is an
incoming call, and resumes when your
phone call ends.
After successful Bluetooth connection,
play audio on any connected device.
» Audio streams from your Bluetooth
device to the speaker.
Disconnect a device
• Press and hold for two seconds;
• Turn o the speaker;
• Disable Bluetooth on your device;
or
• Move the device beyond the
communication range.
Reconnect a device
• When you turn on the speaker,
it tries to reconnect the last
connected device automatically;
• If not successful, select [Philips
BT6700] on your Bluetooth menu
to start reconnection.
Clear pairing information
Press and hold for 10 seconds.
Control your phone call
After Bluetooth connection, you can
control an incoming call with this
speaker.
Button Function
Press to answer an
incoming call.
Press and hold for two
seconds to reject an
incoming call.
During a call, press to end
the current call.
During a call, press and
hold for two seconds to
transfer the call to your
mobile device.

7EN
5 Other
features
Listen to an external
device
With this speaker, you can also listen
to an external audio device such as an
MP3 player.
Note
•Make sure that music playback through
Bluetooth is stopped.
1 Open the protective cover on the
left of the speaker.
2 Connect an audio input cable (not
supplied) with a 3.5 mm connector
on both ends to
• the AUDIO IN socket on this
speaker, and
• the headphone socket on the
external device.
3 Play audio on the external device
(refer to its user manual).
Tip
•When you start music streaming from
a connected Bluetooth device, the
speaker switches to the Bluetooth source
automatically.
Adjust volume
During music playback, rotate the knob
to increase or decrease volume.

8EN
6 Specifications
Note
•Product information is subject to change
without prior notice.
Rated output
power
(Amplier)
12W RMS
Acoustic
frequency
response
100-20000 Hz
Speaker driver 2 x 1.5” full range, 8 Ω
Bass
enhancement
2 x passive radiator
Bluetooth
version
V4.0
Bluetooth
supported
proles
HFP V1.5, A2DP V1.2,
AVRCP V1.4
Bluetooth
frequency band
/ Output power
2.400GHz ~
2.483GHz ISM Band
/ ≤4dBm (Class 2)
AUX input level 650mV RMS
Water
resistance
IPX4
Built-in battery Li-ion battery
(3.7 V, 4400 mAh)
Play time in
battery mode
Approx. 8 hours
Dimensions
- Main unit
(W x H x D) 188 x 71 x 70 mm
Weight -
Main unit
0.5 kg
7 Trouble-
shooting
Warning
•Never remove the casing of this device.
To keep the warranty valid, never try to
repair the system yourself.
If you encounter problems when using
this device, check the following points
before requesting service. If the problem
remains unsolved, go to the Philips Web
page (www.philips.com/support). When
you contact Philips, make sure that the
device is nearby and the model number
and serial number are available.
General
No power
•Recharge the speaker.
No sound
•Adjust volume on this product.
•Adjust volume on the connected
device.
•In AUDIO IN mode, make sure that
music playback through Bluetooth
is stopped.
•Make sure that your Bluetooth
device is within the eective
operational range.
The LED indicator is solid red, and
the speaker has no repsonse when
pressing any key.
•The speaker is in demo mode. To
exit this mode: after connecting to
AC power, press and hold , turn on
the speaker, then release the key
after 20 seconds.

9EN
About Bluetooth device
The audio quality is poor after
connection with a Bluetooth-enabled
device.
•The Bluetooth reception is poor.
Move the device closer to this
product or remove any obstacle
between them.
Fail to nd [Philips BT6700] on your
device for pairing.
•Press and hold for two seconds
to enter pairing mode, and then try
again.
Cannot connect with the device.
•The Bluetooth function of the
device is not enabled. Refer to the
user manual of the device for how
to enable the function.
•This product is already connected
with two Bluetooth devices. Press
and hold for two seconds, and
then try again.
The paired device connects and
disconnects constantly.
•The Bluetooth reception is poor.
Move the device closer to this
product or remove any obstacle
between them.
•For some devices, Bluetooth
connection may be deactivated
automatically as a power-saving
feature. This does not indicate any
malfunction of this product.

2016 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license.
BT6700_00 _UM_V1.0