Crescent SC6500 User manual

Troubleshooting
Guide
SC6500
www.crescentindustrial.co.uk

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brushes
don’t work as
they should?
SC6500
www.crescentindustrial.co.uk
1 Check if the brush are correctly in-
stalled and not worn out.
2 Check if there isn’t any brush motor
overload i.e. 3 battery Ledsflash si -
multaneously.
3 Check if there are external materials
avoiding brush rotating.
1 Check if the suction hose is
correctly installed and cleaned.
2 Open the recovery tank and check
if the vacuum grid and gasket are
cleaned.
3 Check if squeegee blades are
damaged or dirty.
4 Close the recovery tank cover prop-
erly and/or verify the gasket wear.
1 Check if you have the right water
settings.
2 Check if the solution tap is open. 3 Check if the solution filter is
cleaned.
1 Check battery charge gauge. 2 Check that the drive pedal is re -
sponding and all circuit breakers are
armed.
3 Check battery cables are well con -
nected together.
4 Recovery tank seal cover must
correctly installed and in good
condition.