Crescent SC8000 Operating instructions

User and
Maintenance
SC8000
www.crescentindustrial.co.uk
Guide

SC8000
www.crescentindustrial.co.uk
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.
3. Fill the Ecoflex tank with a
detergent suitable for the work to
be performed (highly concentrated
detergent)
4. Install the squeegee and fasten it
to its assembly then connect the
vacuum hose to the squeegee
5. Adjust Squeegee height and
inclinatione.
18. Take the squeegee off, check the
blades wear status
16. Remove and clean the hopper 17.Remove and clean the brushes 19. Remove the side skirts and check
the blade status
20. Clean the machine using a damp
cloth and park it with the recovery
tank open
13.E mpty the recovery tank with the
hose. Then empty the solution tank
with the transparent hose
11.Press the forward pedal and start
operating the machine – all
functions will activate upon the
motion of the pedal
12. Press the EcoFlex™ switch when-
ever you temporarily need a greater
cleaning power
14. Wash with clean water the recov-
ery tank and the vacuum grid.
Remove and clean the debris tray
15. Close the solution tank valve and
remove and clean the filter
8. Lower the deck and select the
desired scrubbing pressure
(squeegee lowers automatically)
6. Install the cylindrical broom/side
brush or brooms
7. Turn the ignition key to “I” and
press the throttle button (if you
want to raise your rpm from idle)
9.Adjust to the desired water flow 10. Adjust to the desired chemical
concentration (shown in the
display)
2. Fill the tank with clean water. The
clean water temperature must not
exceed 40 °C
1. Check the Diesel fuel tank level /
LPG bottle charge. In case re-fill/
change the LPG Bottle