Crestron DM-NVX-E30 User manual

The Crestron DM-NVX-E30 is a network AV encoder that transmits ultra
high-definition 4K60 4:4:4 HDR video over standard Gigabit Ethernet to
a DM NVX® decoder. The DM-NVX-D30 is a network AV decoder that
receives ultra high-definition 4K60 4:4:4 HDR video from a DM NVX
encoder.
The DM-NVX-E30 provides a single HDMI® input, and the DM-NVX-D30
provides a single HDMI output. Both devices feature secure web-based
control and management, an analog audio output, and copper LAN
connectivity.
In the Box
1 DM-NVX-E30 or DM-NVX-D30
Additional Items
1 Connector, 4-Pin (2003576)
2 Connector, 5-Pin (2003577)
Install the Device
The DM-NVX-E30 and DM-NVX-D30 can be mounted onto a flat
surface or onto a rack rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a flat
surface such as a wall or the underside of a table. The screw diameter
should be no more than 6mm. Be sure to use the mounting hardware
that is appropriate for the surface to which the device is being mounted.
NOTE: Fan ventilation holes are provided on five sides of the device.
Ifthe installation necessitates that another object be positioned
flush against the ventilation holes on one side of the device, leave a
minimum clearance of 2 inches of space on all other sides containing
ventilation holes.
Wall Mounting (DM-NVX-E30 Shown)
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder
1

Mounting onto a Rack Rail
Using two rack mounting screws (not included), mount the left or right
mounting flange of the device onto the front or rear rail of a rack.
Rack Rail Mounting Example (DM-NVX-E30 Shown)
Connect the Device
Connect the device as required for the application.
NOTES:
lThe Ethernet port must be connected to a 1000BASE-T switch in
order to stream network video.
lThe DM-NVX-E30 and DM-NVX-D30 can be powered via the
Ethernet port, which is a PoE+ powered device (PD) port. In order
for the device to receive PoE+, the Ethernet port must be
connected to a PoE+ port of an Ethernet switch. Alternatively,
the DM-NVX-E30 and DM-NVX-D30 can be powered by a
24VDC power pack (sold separately).
2
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder

DM-NVX-E30 Front Panel Connections
DM-NVX-D30 Front Panel Connections
3
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder

DM-NVX-E30 and DM-NVX-D30 Rear Panel Connections
4
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder

AUDIO Connector Pin Assignments
The AUDIO connector uses a 5-pin terminal block for balanced or
unbalanced analog audio output.
AUDIO Connector
Refer to the following table and diagram for analog audio output pin
assignments and connection information.
Signal Name Balanced Audio Output Unbalanced Audio Output
+ L+ L+ Out
− L− Open
G Shield/ground Common ground
+ R+ R+ Out
− R− Open
Upgrade the Firmware
Before using the device, upgrade the firmware. The latest firmware can
be downloaded from the DM-NVX-E30 and DM-NVX-D30 product
pages on the Crestron website (www.crestron.com).
Configure the Device
Configure the device using the web interface. To access the web
interface, open a web browser and then go to the IP address of the
device.
NOTE: By default, the IP address of a DM NVX device is assigned by
a DHCP server on the network. If a DHCP server does not exist on
the network, the IP address defaults to a link-local address in the
169.254. xxx . xxx range (refer to RFC 3927 for detailed information
about link-local addressing). To display the IP address on the
connected display, press the SETUP button on the rear panel of
thedevice.
If no account has been created, create an account by entering a user
name and password and confirming the password. After an account is
created, sign in to the web interface by entering the user name and
password.
5
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder

Connect to the Cloud
The XiOCloud®service allows supported devices across an enterprise to
be managed and configured from one central and secure location in the
cloud. Supported Crestron® devices are configured to connect to the
service out of the box.
Use of the service requires a registered XiOCloud account. To register
for an XiOCloud account, refer to
www.crestron.com/Support/Tools/Licensing-Registration/XiO-Cloud-
Registration-Room-Licenses.
To connect the device to the XiOCloud service:
1. Record the MAC address and serial number that are labeled on the
shipping box or the device. The MAC address and serial number are
required to add the device to the XiOCloud service.
NOTE:If the device has multiple MAC addresses, use the MAC
address that is providing the primary connection back to the
network. For most devices, the Ethernet MAC address should be
used. However, if your device is connecting to the network over a
different protocol (such as Wi-Fi® communications), use the MAC
address for that protocol instead.
2. Log in to your XiOCloud account at portal.crestron.io.
3. Claim the device to the XiOCloud service as described in the
XiOCloudUserGuide.
Select the device from the cloud interface to view its status and
settings. The device may now also be managed and assigned to a group
or room. For more information, refer to the XiOCloudUserGuide.
NOTE:For XiOCloud accounts with room-based licenses, the device
must be added to a licensed room before its status and settings can
be viewed.
Observe the LED Indicators
Refer to the following table for information about the LED indicators on
the device.
LED Indicator Color Meaning
PWR Amber Power is being applied to the
device. Thedevice is booting.
Green Power is being applied to the
device. Thedevice is
operational.
SETUP Red The SETUP button is pressed.
NV Green (DM-NVX-E30 only) The
device is encoding
(transmitting) network video.
(DM-NVX-D30 only) The
device is decoding (receiving)
network video.
OL Green The device is online with a
control system via Ethernet.
Ethernet Green An Ethernet link is
established.
Flashing amber Data activity is occurring on
the Ethernet link.
HDMI INPUT
(DM-NVX-E30 only)
Green An HDMI signal is detected at
the HDMI input.
HDMI OUTPUT
(DM-NVX-D30 only)
Green An HDMI signal is being
transmitted at the HDMI
output.
6
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder

Visit the Product Page
Scan the QR code to visit the product page.
DM-NVX-E30
www.crestron.com/model/6511506
DM-NVX-D30
www.crestron.com/model/6511507
Additional Information
Original Instructions
The U.S. English version of this document is the original instructions.
All other languages are a translation of the original instructions.
Regulatory Model: M202013001
Crestron product development software is licensed to Crestron dealers and Crestron
Service Providers (CSPs) under a limited nonexclusive, nontransferable Software
Development Tools License Agreement. Crestron product operating system software is
licensed to Crestron dealers, CSPs, and end-users under a separate End-User License
Agreement. Both of these Agreements can be found on the Crestron website at
www.crestron.com/legal/software_license_agreement.
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at
www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, visit
www.crestron.com/opensource.
Crestron, the Crestron logo, DM NVX, and XiO Cloud are either trademarks or registered
trademarks of Crestron Electronics, Inc. in the United States and/or other countries. HDMI
and the HDMI logo are either trademarks or registered trademarks of HDMI Licensing LLC
in the United States and/or other countries. Wi-Fi is either a trademark or registered
trademark of Wi-Fi Alliance in the United States and/or other countries. Other
trademarks, registered trademarks, and trade names may be used in this document to
refer to either the entities claiming the marks and names or their products. Crestron
disclaims any proprietary interest in the marks and names of others. Crestron is not
responsible for errors in typography or photography.
©2022 Crestron Electronics, Inc.
Doc. 8906B
04/07/22
7
DM-NVX-E30 and DM-NVX-D30 QuickStart
DM NVX® 4K60 4:4:4 HDR Network AV Encoder and Decoder