DO GUIDE DOC. 7788C (2043903) 07.15
Specications subject to change without notice.
7. Test the installation by pushing the button on the right side of the bezel to open the cradle.
Then, push the cradle to close it.
DO Dock the Touch Screen
To dock the touch screen, use the following procedure:
1. Push the button on the right side of the bezel to open the cradle.
2. Place the bottom of the touch screen into the cradle, and then push the top against the
magnets on the cradle.
3. Push near the top of the touch screen to close the cradle.
DO Undock the Touch Screen
To undock the touch screen, access the setup screens. Then, from the Diagnostics screen,
select Dock Test to display the Diagnostics - Dock screen. Both External Power and Wall
Dock Detected should be lit. Tap Press to Release From Wall Dock to open the cradle so the
touch screen can be removed.
In the event of a power failure, the touch screen can be manually undocked using the following
procedure:
1. Insert the key that ships with the TST-902-DSW into the gap between the top of the touch
screen and the dock. Make sure the text on the key is facing upward.
2. Rotate the key downward as shown in the following illustration.
3. Withdraw the key to open the cradle so the touch screen can be removed.
DO Learn More
Visit the website for additional information and the latest rmware updates. To
learn more about this product, use a QR reader application on your mobile device
to scan the QR image.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has been tested and found to comply with specications for CE marking.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modications not expressly approved by the manufacturer responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
The specic patents that cover Crestron products are listed at patents.crestron.com. The product warranty can be found at www.crestron.com/warranty.
Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks,
and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names
of others. Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2015 Crestron Electronics, Inc.
