Crolla NEXUS User manual

MODEL:NEXUS
www.crollababy.com

Steps to buckle the harness
Engage the buckle connecter until it clicks.

Pull the shoulder straps out of the harness connector as picture shown;
following the order ①②③, exit two shoulder straps from the harness
connectorat the back of the child seat.
Exit two shoulder straps from the harness connector at the back
of the child seat. Pull the shoulder straps out of the slot in front of
the child seat, remove chest pad and infant insert.
Step 2: Remove the harness from the harness connector, detach the snaps
and the hook and loop fasteners from the shoulder straps. Lift the upper flap
upward and pull the lower flap forward, and then store the shoulder straps at
the back. Pull the buckle to the back of the seat pad, and then store the buckle
and buckle tongues in respective storage compartment.

Step 1: Adjust the seat to rear
facing position (position 3), place
the child seat on the car seat and
make sure that the car seat is
firmly pressed against the car
seat backrest.
Step 2: Remove infant insert, pass
the waist belt over seat slots, and
then engage the vehicle buckle
tongue into the buckle.
Step 3: Fasten the shoulder belt
in the shoulder-belt slots at the
back of the body. Place infant
insert back to the car seat.
Step 2: Pass waist belt through
seat slots.

Step 3: Fasten buckle and pull the vehicle belt to tighten. Check the height of the harness is
in the correct position and then fasten the buckle. Position shoulder belt
through shoulder belt guide, pass waist belt through seat
slots. Fasten buckle and pull the vehicle belt to tighten.

598
Length
Width
Height
475
618
475
618
598