Crolla ALLY User manual

5
ATTACHING THE BASSINET ADJUSTING TO CO-SLEEPING MODE
6
1. Zip up the bassinet and secure
the zipper head with buckle,
then cover it with flap.
Before setting up bassinet, make sure all rails have become rigid.
The bassinet must be fully assembled and installed before using
The travel cot can be fixed to the parent’s bed (co-sleeping mode).
1. Slide the adjustor inwards as photo shown
2. Adjust the slide door down
3. Position the travel cot next to the bed
4. Lift up the slide door when parents is not around.
Care and Maintenance
1. Your travel cot can be spot cleaned with a sponge and soapy water.
2. Do not use undiluted neutral detergent, gasoline or other organic
solvent to wash the travel cot. It may cause damage to the travel cot.
3. To wash carry bag, machine wash in lukewarm water and drip-dry. Do not use bleach.
4. At the beach or in the garden, clean sand and grit off your travel cot.Sand in the long
rail locks may cause damage.
5. From time to time, check your travel cot for worn parts, torn material or stitching.
Replace or repair the parts as needed.
6. If the travel cot is not in use for a long period of time, please put it in the shade where
your child cannot access it.
4. Assemble the
connecting tubes
as picture shown.
5. Place the mattress
into the bassinet.
Place mattress, soft side up
3. Slide two tubes in the pocket
as picture shown.
2. Must zip up the bassinet
completely without crevice
before using.
2
PRESS TO UNLOCK
PRESS TO UNLOCK
PRESS TO UNLOCK
1
PRESS TO UNLOCK
PRESS TO UNLOCK
1
6
PRESS TO UNLOCK
PRESS TO UNLOCK
PRESS TO UNLOCK

2 3 4
INTRODUCTION
ASSEMBLY
FOLD TRAVEL COT
• Adult assembly required.
• Please save instruction manual for future reference.
• Read all the instructions in this manual before using product.
• Discontinue using travel cot when child reaches 15kg
(approximately 86cm in height) or is able to climb out.
• Discontinue using bassinet when child can sit,
kneel or roll over or pull itself up.
• The lowest position of the mattress is the safest and the base
shall always be used in that position as soon as the baby
is old enough to sit up.
• Failure to follow these warnings and instructions could result in danger.
• Do not use the cot if any part is broken, torn or missing and
use only spare parts approved by the manufacturer.
• NEVER leave your child unattended. Always keep your child in view.
• Use the travel cot with only one child at a time.
• Do not use more than one mattress in the travel cot.
• DO NOT leave anything in the travel cot or place the travel cot close to
another product, which could provide a foothold or present a danger of
suffocation or strangulation, e.g. strings, blind curtain cords etc.
• Always use travel cot on a flat, level floor.
• Be aware of the risk of open fire and other sources of strong
heat such as electric bar fires, gas fires, etc in the near vicinity
of the travel cot.
• To avoid strangulation, DO NOT place items with a string
around your child’s neck, suspend strings from this product,
or attach strings to toys.
• All assembly fittings should always be tightened properly and
that fittings should be checked regularly and retightened
as necessary.
• Make sure the product has been folded or unfolded completely
before letting your child approach the travel cot.
• You must attend to your child while it is in the bassinet.
Do not place the bassinet in a dangerous place.
• Always keep accessories out of child’s reach. Remove the
accessories when child is able to pull itself up in the travel cot.
• Only use the mattress sold with this cot, do not add a second
mattress on this one, suffocation hazards.
Please read all the instructions in this manual before setting up and using this product.
1. Undo the two hook and loop fasteners.
2. Remove base mattress.
3. Pull the short rails up until both become rigid. If not rigid, pull up again until they are rigid.
If short rails do not latch, raise the center of floor halfway up, and then pull up again to latch the rails.
4. Latch the long rails.
5. Push the center of floor down. (Be sure all rails have locked before lowering center.)
6. Place the mattress
7. While installing mattress, soft side up
8. The travel cot is now ready to use.
9. Remove the mattress.
10. Pull the folding webbing upward. Do not unlock rails yet. Center of floor must be halfway up before rails will unlock.
11. Unlock all four rails by following these steps.
- Slightly lift the center of the rails, squeeze the latch button on the rail to release the two tubes.
- Do not force fold. ! Both tubes must be released for the rail to fold, if rail does not fold completely, please lift the center of floor higher,
and then try again from step
12. Fold the unit, but do not force. If unit will not fold, look for a partially latched rail. Squeeze the latch button to release the rail.
13. Wrap the travel cot with the mattress. Guide the hook and loop fasteners through the rings and attach them.
14. Place the travel cot into the bag and zip it.
15. The travel cot is now ready for easy carry and storage.
15 kgs.