Crown Audio, Inc.
P.O. Box 1000
Elkhart, IN 46515-1000
TEL: 574-294-8200
FAX: 574-294-8FAX
www.crownaudio.com
SST-MX
4/03 132299-1A
SYSTEM SOLUTION TOPOLOGIES
Crown’s Three-Year, No-Fault, Fully Transferable Warranty
Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown amplifier
product—an unsurpassed industry standard. With this unprecedented No-Fault protection, your
new Crown amplifier product is warranted to meet or exceed original specifications for the first
three years of ownership. During this time, if your unit fails, or does not perform to original
specifications, it will be repaired or replaced at our expense. About the only things not covered
by this warranty are those losses normally covered by insurance and those caused by intentional
abuse. And the coverage is transferable, should you sell your unit.
See your authorized Crown dealer for full warranty disclosure and details. For customers outside
of the USA, please contact your authorized Crown distributor for warranty information or call
574-294-8200.
The Crown SST-MX module is a fourth-
order Linkwitz-Riley type crossover with a
fixed crossover point set at 100 Hz. Truly
a professional crossover, the SST-MX uses
hard-wired precision components that stay at
the frequencies you have selected for consis-
tent bandwidth control.
SST (System Solution Topologies) modules
install into the back of Crown SST-compatible
amplifiers, saving rack space and simplifying
system wiring.
For more details about the Crown SST-MX,
contact the Crown Technical Support Group at
800-342-6939 or 574-294-8200. Also, visit the
Crown Audio website at www.crownaudio.com.
Specifications
Frequency Response: ±0.1 dB from 20 Hz to
20 kHz.
Signal to Noise (A-Weighted): Better than 85
dB below rated power.
Input Impedance: 20 k ohms balanced, 10 k
ohms unbalanced.
Output Impedance: 600 ohms balanced.
Total Harmonic Distortion (THD): 1 kHz rated
power, less than 0.1% true THD.
Crosstalk: > 50 dB from 20 Hz to 20 kHz.
Maximum Output: +18 dB into 600 ohms.
Specifications subject to change without prior notice. Latest
information available at www.crownaudio.com.
Crown is a registered trademark of Crown International, Inc.
Other trademarks are the property of their respective owners.
Printed in U.S.A.
© 2003 Crown Audio, Inc.
Features
• Stereo biamp.
• 24-dB/octave Linkwitz-Riley crossover fixed
at 100-Hz.
• Stereo sub outputs.
• SST modules install into the back of your
amplifier, saving rack space and simplifying
system wiring.
• Neutrik®Combo input jacks.
• Barrier block balanced outputs.
• Optional high-pass filter bypass on amplified
outputs adapts system for full-range use.
• SST Modules add flexibility by allowing you to
tailor your Crown Contractor (CH/CL) Series
or CE Series amplifier to your application.
SST-MX Block Diagram
