CROYDON
CROYDON
FA25M-200001 A5
ELECTRICAL FRYER - MODEL: FA25M-200001 A5
-Please read these instructions carefully before operating this appliance.
-The temperature is thermostatically controlled between the range of 80°C to 200°C(176°F to 392°F). A
signal lamp adjacent to the thermostat indicates when the heating element is energized.
SAFETY
-This appliance is designed to operate on alternative current (A.C.) Only
-DO NOT CONNECT TO DIRECT CURRENT (D.C.).
-Care should be taken when operating this appliance, as HOT SURFACES may cause burns.
-WARNING! Hot oil can cause burns. Spilling oil can cause severe burns. Do not move fryer without
draining all the oil from the tank.
-Do not over fill baskets. Carefully load them into hot oil. A danger of surge boiling can also occur if the
food to be fried is excessively wet or the frying basket is too full.
-It is dangerous to use old oil as this can reduce the flash point and cause surge boiling.
-Ensure that power supply cord does not come into contact with hot surfaces.
- When not in use for long period unplug the appliance.
INSTALLATION AND OPERATION
-Before connecting your appliance check if voltage of your power system corresponds to the unit
label.
-Fill the container with 46.9 lbs (23 liters) of quality oil (fat).
-Prepare a solution with 2 liters of water and 300 g of salt, mixing until it becomes homogeneous.
-Add the solution in the container until it reaches the second mark.
- Wait about 10 minutes to solution get deposited in the bottom avoiding contact with the heating
element.
-Set thermostat to desired operation temperature (table 1) and pilot light will turn on. As soon pilot
light turns off, appliance has reached desired temperature .
-The basket should be filled up to 2/3 of the capacity.
-To turn off your unit turn knob completely towards left.
-In a matter of assuring better quality in the fry and longer durability of the oil, the solution should be
changed daily by doing what follows:
1- Open the tap (located in the inferior part of the container);
2- Drain the solution with all dust that comes within. Don’t drain the oil.
3- If necessary complete the oil level.
4- Add a new solution.
WARNING!
- UNPLUG THE APPLIANCEAFTER USE.
CLEANING PROCEDURE
-Always ensure that the appliance is disconnected from the main power supply before cleaning.
-Wait until oil cools and proceed as follows:
- Remove installation box.
- Remove oil container and empty the oil and solution.
-Appliance should not be cleaned with a water jet or immersed in water. Use only a damp cloth or sponge
dipped in soapy water.
-Wipe off appliance with a dry cloth and wait at least half an hour before re-connecting to main power
outlet.
INSTRUCTION MANUAL
50
250
0
20
0
5
1
00
1
L
S
E
D
C
º
20
3
122
12
2
2
30
2
93
2
48
8
60
F
º
OF
F
The pictures/drawings are illustrations. All data can be changed without notification.
CROYDONMAQ INDUSTRIAL LTDA.
Estrada São Lourenço, 891 - Capivari
Duque de Caxias - RJ / Brasil - CEP 25243-150
Phone: 55 21 2777- 8100 / 55 21 2777-8106
