Crystal Acoustics 3D-HIFI360 User manual

Thank you for purchasing Crystal Audio 3D-HIFI360 system
This mini Hi-Fi system is the answer to today’s demand for great sound, offering deep and powerful bass with incredible dispersion.
Small yet powerful Hi-Fi system, it produces excellent sound with realistic height from a wide sound stage.
TECHNICAL SPECIFICATIONS:
3D-HIFI360
Power Output (RMS):
Max. Power Output:
Woofer:
Tweeter:
Freq. Response:
Impedance:
S/N:
Frequency Ranges:
MP3/WMA Bit Rate:
Rated Voltage:
Power Consumption:
Standby Consumption:
Dimensions (Main unit):
Dimensions (Speakers):
50W (2x 25W)
75W
2x 4”
6x 2”
20Hz - 20KHz
4Ω
80dB
87.5 - 108MHz
32-320Kbps (MP3)
40-320Kbps (WMA)
AC 110-240V, 50/60Hz
75W
< 0.5W
170x215x145mm
142x210x245mm (each)
www.CrystalAudio.gr
CONNECTIVITY FEATURES:
OTHER FEATURES:
IN THE BOX:
• Bluetooth® v5.0
• USB2.0 port
up to 32Gb, FAT16/32 file system
NTFS, ext. HDD, USB hubs/extension cables
• AUX In
• Headphones
• CD/CD-R/CD-RW/MP3/WMA
• FM Radio
• LED Display
• 3D-HIFI360 mini Hi-Fi system
• User Manual
• Remote Control
• AUX cable (3.5mm-RCA type)
• FM Antenna cable
USB
Front View
USB
port
CD
tray
ON/OFF
Standby button
Control
buttons
IR
Remote
sensor
Phones
Volume
knob
- Quick Guide -

Tune it (choose radio stations)
6
Select it (choose mode)
Press SOURCE button on the main unit
or on the Remote Control to switch
between the available modes.
4
Bluetooth USB AUXFMCD
Set it up
Connect the speakers to the unit:
Connect each speaker cable to the respective SPEAKER port.
Connect the Antenna cable:
Connect the Antenna cable to the ANTENNA FM input port.
Connect the unit to the outlet:
Connect the mains plug into the electrical outlet.
1Install Batteries:
Slide out cover and place 2 AAA type
batteries (not inluded) with polarities as
shown below.
Pair it (wireless connection)
You can pair 3D-HIFI360 with any Bluetooth®enabled device (phone, tablet etc).
2
1. Press the SOURCE button to select BT
(Bluetooth Mode). The indication on the LED
Display flashes continuously and the device
automatically searches for available
Bluetooth devices.
2. On your device,
turn BLUETOOTH on
and make it discoverable.
Search for 3D-HIFI360 and
select it.
3. The indication stops flashing.
The devices are now paired.
3D-HIFI360
* In case of an old Bluetooth version (below v3.0)
you might be asked for a code. Please enter “0000”.
Use it (wired connection)
1. LINE IN: Connect both Left & Right channels to your device Output
2. USB: Play songs directly from your USB flash drive
3. Headphones: Connect to the headphone Output of your device
31. LINE IN 2. USB port 3. Headphones
3.5mm
REMOVE USB:
In order to safely eject
the USB flash drive,
change the SOURCE
before removing it.
�
Preset it (up to 40 radio stations)
5
1. In FM mode:
Press GOTO
2. On LED display:
3. Num. Keypad:
Enter FM frequency
4. Goto Frequency:
Press PLAY
5. Once tuned:
Press MEMORY
6. Set Position:
Press CH-/+
INFO:
To select a radio station
press a key (1-10) on the
Remote Control.
To select a station from
number 11 to 40, press
10+ and enter the desired
number of the station.
PAI R
In FM mode:
Press FF-/+
a. In FM mode: Press
Search on Remote Control
b. In FM mode: Press
PLAY/PAUSE on the main unit
MANUAL AUTO AUTO

Program it (create a playlist, up to 9 songs)
1. In CD mode: Load a disc and press STOP. Press PROG and enter the first track number.
Press PROG again to confirm. Enter the second number and follow the same procedure to set your playlist.
2. Play the list: When the list is completed press PLAY to confirm and listen to the music.
Loop it (play a section of a song)
In CD/MP3 mode:
1. Press A-B button once to set In (Start) point.
2. Press A-B button again to set Out (End) point.
Care & Maintenance
Compact discs:
1. Treat disc carefully holding it by its edges.
2. Clean with a soft, dry cloth. Wipe from
the center to the outer edge of the disc.
Do not wipe in circular direction.
3. Do not stick or write anything
on either side of the disc.
Control it
7
8
10
9
PAI R
Eject
Open compact disc tray
Numeric Keypad
Select track number
GoTo
Enter FM Frequency
Next Track
Play
Previous Track
Stop
Pause
Pause the music
CD/USB
Select CD or USB mode
Source
Switch between all modes
Random
Play tracks in random order
Search
Auto tunning (FM Radio)
FF -/+
Manual tunning (Radio stations)
Reset
Back to factory deafult options
BT
Select Bluetooth mode
Treble -/+
Treble adjustment
Bass -/+
Bass adjustment
Prog
Create a playlist (up to 9 tracks)
Intro
Play the 10 first seconds of
each track on the disk. Press
again to cancel the function Pair
Search for Bluetooth devices
Memory
Preset a radio station
Repeat
Press 1 time: Repeat only one track
Press 2nd time: Repeat all tracks
Press 3rd time: Stop Repeat function
A-B
Loop a section of a song
CH -/+
Select Next/Previous Radio station
VOL -/+
Adjust Volume level
EQ
Rock/Jazz/Pop/Flat
Mute
Mute the sound
Rewind
Forward
ON/OFF
Unit:
1. To prevent shock hazard
disconnect from the AC power
source when cleaning the device.
2. Clean with a dry cloth.
A dump cloth may be used on
the front panel.
Press A-B:
1x= set START point
2x= set END point
The specific part of the song
will be played repeatedly.

SPEAKERS (4Ù) LINE IN
FM (75Ù)
ANTENNA
POWER SUPPLY:
CONSUMPTION:
STANDBY MODE:
110-240V 50/60Hz
50W
<0.5W
This product has been designed and engineered by Crystal Audio in Europe
and manufactured with the highest quality standards in China
RISK OF ELECTRIC SHOCK
DO NOT OPEN
www.crystalaudio.com
MODEL: 3D-HIFI360 1904
Speakers Audio In
Mains
Antenna In
General instructions
Please read these safety instructions before using your device and store them for possible
future reference.
1. If the cord is damaged, have it repaired by the manufacturer, its service or a similarly
qualified person in order to avoid any hazard.
2. The power supply must be replaced by a new one in case of malfunction, because this
power supply is not repairable.
3. The socket outlet shall be installed near the equipment and shall be easily accessible
4. The product is not intended for use by persons (including children) with reduced physi
cal, sensory or mental capacity. Persons who have not read the manual, unless
they have received explanations by a person responsible for their safety
and supervision, should not use this unit.
5. Children should be monitored to ensure that they do not play with the product.
6. The cord should always be readily accessible.
7. The device should not be exposed to dripping or splashing of water or liquids and
no objects filled with liquids, e.g.flower vases, should be placed on the product.
8. The normal ventilation of the product shall not be impended for intended use.
9. It is recommended to leave a minimum distance of 10 cm around the unit to ensure
sufficient ventilation.
10. Open flame sources, such as candles, should not be placed on top of the device.
11. The device is intended for use only in a temperate climate.
12. CAUTION:
Danger of explosion if battery is incorrectly replaced or not replaced by the same type
or equivalent.
13. The battery should not be exposed to excessive heat such as sunshine, fire or similar.
14. Different types of batteries, new and used batteries should not be mixed.
15. The battery must be installed according to the polarity.
16. If the battery is worn, it must be removed from the product.
17. The battery must be disposed of safely. Always use the collection bins provided for
recycled items in order to protect the environment.
Warnings
1. The lightning flash with the arrowhead symbol within an equilateral
triangle alerts the user to the presence of un-insulated dangerous voltage
within the product’s enclosure that could cause electric shock.
2. The exclamation mark within an equilateral triangle alerts the user to
the presence of important operating and maintenance instructions as well
as warnings in the user’s manual or on the product.
Designed in Europe by Crystal Audio - Assembled in China with the highest quality standards.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG Inc. and any
use of such marks by Crystal Audio is under license. Other trademarks and trade names are those of
their respective owners.
CLASS 1 LASER PRODUCT LABEL
This label is attached to the place as illustrated to inform that this device
contains a laser component.
CLASS 1 LASER PRODUCT
CLASSE 1 LASER PRODUTO
KLASS 1 LASER APPARAT
KLASSE 1 LASER PRODUKT
CLASSE 1 PRODUIT LASER
Rear View
DECLARATION OF CONFORMITY
Radio equipment and telecommunications terminal equipment, Directive 2014/53/EU
Crystal Audio hereby declares that the product, 3D-HiFi360, is in conformity with provisions of the Directive 2014/53/ΕU.
The complete text of the Declaration of conformity can be found on the following webpage: www.CrystalAudio.com