CSE Medical ECG EXPERT User manual

Medical-CSE© 2014
ECG EXPERT
Owner’s Manual
v 1.4
Rev: 2016-01-10

1. Product Descripon
2. Intended use
3. Indicaons
4. Counter indicaons
5. Side eects
6. Safety Informaon
Warnings
7. ECGExpert User Manual
8. Supplied equipment
9. ECGExpert Device
10. Technical Specicaons
11. Symbols
12. Connecng the electrode cables
13. Electrode Selecon
14. Turning ON the device
15. Turning OFF the device
16. Inspecon, Cleaning, Storage and Transport
17. Maintenance
18. Interferences and EMC requirements
19. Use with debrillator
20. Pacemakers
21. ECGExpert
22. ECGExpert - Conguraon
Visualizaon Conguraon
Filter Conguraon
Admin Conguraon
23. ECGExpert version – ECG Capture
Electrode Status
Tools
Fast ECG
24. ECGExpert version - Paents
25. ECGExpert version - Reports
26. Reports
27. User Guide and Troubleshoong
28. Requirements for a good Wireless network link
3
3
4
4
4
4
4
5
6
6
9
11
12
13
13
14
14
15
16
17
17
18
18
18
18
19
19
20
20
20
20
21
21
22
25
Table of Contents

ECGExpert includes the following equipment:
· 1 Acquision Module
· 10 labelled ECG cables
· 1 USB Cable
· 1 Power Supply for baery charge
acquision process of the signals obtained
from the electrodes.
The expected user for the analysis of
the reports generated by the device is a
medical praconer with experse on
ECG signal analysis.
ECGExpert is designed to measure ECG
signals in roune reviews of paents in
both, ambulatory or non-ambulatory,
environments. An addional computer
device (tablet-PC, smartphone or PC),
with Bluetooth connecvity, is required
to visualize the acquired signals. Data is
stored on the computer device for further
analysis by a medical praconer.
The expected user has basic knowledge
of ECG measurements and is able to place
the electrodes on the paent body, as well
as able to verify that these connecons
are correct and able to start the data
1. Product Descripon
2. Intended use

This device is able to capture electrocardiograms from 6 or 12 signals, data forwarding
and analysis, for later diagnosis by a qualied medical praconer.
3. Indicaons
None detected.
None detected.
In this manual, a Warning idenes condions and dangerous acons that may result
in injuries or fatal injuries. A Cauon idenes scenarios and acons that may result in
damages on the product or on the visualizing equipment, or cause data loss.
4. Counter indicaons
5. Side eects
6. Safety Informaon
Contact:
Custom Soware & Electronics hp://www.medicalcse.com
C/Marie Curie 8, 08042 – Barcelona (Spain)
Phone: [phone]
Email: servic[email protected]
Warnings
· The equipment must not be modied.
· Do not use if the device is damaged, the cables are damaged or the insulaon is
defecve or damaged.
· Do not use any other ECG cables than those supplied with the device.
· The equipment must be sealed and all its inner parts inaccessible at all me.
· Prevent exposure to direct sunlight during extended periods of me.
· Remove cables with electrodes not needed for data acquision.
· Do not use the equipment in environments with gases, containing explosive
vapours, or in humid or wet environments. Protect the equipment from water, humidity,
or salty/sulphuric environments.

ECG expert will allow you to capture biological signal
from a paent and to obtain an electrocardiogram
(ECG) report, with an autonomous device of reduced
dimensions powered by long lasng baeries.
The device is designed to be operated by users with
minimal medical experse. In order to correctly
capture, ECG signals, it is only required to know the
number of electrodes and the correct placement of
these electrodes on the paent’s body.
7. ECGExpert User Manual
· Do not operate the device while charging baeries.
· Read Safety Informaon before operang the product.
· Examine the product case before use. Verify that the device is not damaged.
Carefully check the external insulaon on the connectors and on the cables connected
to the electrodes.
· Do not use sharp or piercing objects to operate the device.
· Prevent terminals and device to contact any conducve surface while in
operaon.
· Do not use the device close to high frequency power sources (microwaves) in
operaon.
· Ensure that no conducve part of the device (terminals, cables or electrodes)
contact any exterior conducve element (cables, metal surfaces, conducve metal
elements or plugs).
· Do not use the device in an operang room or during a surgical procedure.
To visualize the results an addional computer or portable device (tablet-PC or
smartphone), with bluetooth connecvity, is required. This visualizing device must
have previously installed the ECGExpert applicaon.
ECGExpert device is suitable for direct cardiac applicaons.