CTS Turbo CTS-IT-105 User manual

INSTALLATION GUIDE
MK6 GTI Air Intake Kit
CTS-IT-105
20630 Mufford Crescent, Unit #309
Langley, British Columbia V2Y 2V9
www.CTSTURBO.com

www.CTSTURBO.com Page 2
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
1. CTS high flow air filter
2. Intake pipe
3. Silicon inlet
4. Silicone Block off
5. Heat shield with weather
stripping
1.
2.
3.
4.
5.
WHAT IS INCLUDED
TOOLS REQUIRED
NOTES
1. Pliers
2. T20, T25 Torx
3. 8mm socket
Vehicle used in this guide is a MK5 VW GTI. Always make sure the car is safe to
work on. Do not work on a hot motor. We do not accept any liability for incorrect
installation or damage during the install.

www.CTSTURBO.com Page 3
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
Park your car on a
flat surface and apply
your e-brake.
Unscrew the top
section of the factory
air inlet and remove it
from the engine cover.
STEP 1
STEP 2
Unplug the Mass Air
Flow Sensor.

www.CTSTURBO.com Page 4
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 3
STEP 4
Unclip the engine
cover on the turbo
inlet side.
Remove the engine
cover.

www.CTSTURBO.com Page 5
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 5
STEP 6
Unclip the turbo
inlet hose clamp and
remove the turbo
inlet pipe,
Remove the MAF
sensor from the
engine cover.

www.CTSTURBO.com Page 6
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 7
Install the MAF
sensor on the CTS
Turbo inlet pipe.
STEP 8
Install the silicon
block off using the
provided hose
clamp.

www.CTSTURBO.com Page 7
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 9
STEP 10
Install the silicon
reducer on the
turbo inlet using
the provided hose
clamps.
Remove the lower
portion of the air box
to make room for the
heat shield.

www.CTSTURBO.com Page 8
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 11
Assemble the
heatshield and
install the weather
stripping. You may
need to crimp the
edges of the weather
stripping with a pair
of pliers.
STEP 12
Slide the heatshield
into place.

www.CTSTURBO.com Page 9
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 13
STEP 14
Insert the inlet pipe
and tighten down the
hose clamp at the
turbo inlet.
Fasten the inlet pipe
to the mounting
point under the heat
sheild securing both
into place.

www.CTSTURBO.com Page 10
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 15
Install the air filter.
STEP 16
Plug in the MAF
sensor.

www.CTSTURBO.com Page 11
CTS Intake Kit for MK5 GTI
INSTALLATION GUIDE
STEP 13
You are done!