Cub Cadet 19A30024100 User manual

Bracket Installation
Note: Removing the cutting deck from beneath the tractor
as instructed in your tractor’s Operator’s Manual will ease
installation of this kit.
1. Secure the roller mount to the rear center of the cutting
deck using two carriage bolts (710-3178) and two flange
lock nuts (712-04065) included with this kit. See Figure 1-2.
Note: Feed the carriage bolts up through the bottom of the
deck, then through the roller mount and secure with the
flange lock nuts included.
Figure 1-2
19A30024100 lawn striping kit is designed for use with three-
blade cutting decks found on select Cub Cadet models. Refer
to your machine’s Operator’s Manual or consult your Cub Cadet
dealer to assure compatibility.
Carton Contents
Before beginning installation, remove all parts from the carton to
make sure everything is present. Carton contents are listed below
and shown in Figure 1-1. Part numbers are shown in parentheses.
• One 25.75” Pin (711-05664)
• One Hex Lock Nut (712-3083)
• Two Flange Lock Nuts (712-04065)
• Two Carriage Bolts (710-3178)
• Four Rollers (731-05679B)
• One Roller Mount (683-05135)
Figure 1-1
WARNING: Before beginning installation, place
the tractor on a firm and level surface, set the
parking brake, place the PTO in the disengaged
(OFF) position, stop the tractor’s engine and remove
the ignition key to prevent unintended starting.
InstallatIon Manual
Lawn Striping Kit — 19A30024100
Form No. 769-10196
September 10, 2014
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA

Roller Installation
1. Position the four rollers between the mounting holes on
the roller mountain bracket as shown in Figure 1-3.
2. Insert the pin (711-05664) through the bracket and rollers
and secure it in place with the included hex lock nut (712-
3083). See Figure 1-3. Be sure that the hooked end of the
pin engages the second hole on the left side bracket as
shown in the inset of Figure 1-3.
IMPORTANT: Tighten hex nut until rollers are snug, yet still free
to turn. Do not overtighten.
Figure 1-3
Note: The right side of the roller mounting bracket has two
adjustment holes, while the left side utilizes a elongated
mounting hole. Use the upper hole on the roller mounting
bracket for lower deck setting applications and the lower hole
for higher deck settings. The rollers are not designed to engage
the ground enough that it causes the deck of the mower to pitch
forward.
G
E
N
U
I
N
E
F
A
C
T
O
R
Y
P
A
R
T
S
To order replacement parts, call the Customer Dealer Referral Line at 1-877-282-8684
or visit www.cubcadet.com to find the nearest Cub Cadet dealer in your area.