6
Safety Cautions
Carefully read all the instructions before using the appliance and keep
in a safe place for future reference
Always follow these safety cautions when using this appliance to avoid
personal injury or damage to the appliance. This appliance should be used
only as described within this instruction book.
nEnsure all packaging materials and any promotional labels or stickers
are removed from the Traditional Kettle before first use.
nAlways inspect the appliance before use for noticeable signs
of damage. Do not use if damaged, or if the appliance has been dropped.
In the event of damage, or if the appliance develops a fault, contact the
Cuisinart Customer Care Line (refer to ‘UK After Sales Service’ section
for further information).
nDo not use this appliance if the lead is damaged. In the event of lead
damage discontinue use immediately. If the lead is damaged it must
be replaced with a special lead available from the manufacturer or its
service agent. (See ‘UK After Sales Service’).
nWhilst in use the surfaces will become extremely hot. Do not touch hot
surfaces. Always use handles.
nUnplug from the mains when not in use and before cleaning. Allow to
cool before cleaning the appliance. To disconnect, turn the switch off
and then remove the plug from the mains.
nThis appliance is not intended for use by persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
nChildren should always be supervised to ensure that they do not play
with this product.
nNot for use by children. Keep out of reach of children during and after
use.
nDo not use any accessories or attachments with this appliance other than
those recommended by Cuisinart.
nTo protect against fire, electric shock or personal injury, do not immerse
cord, plug or unit in water or other liquids.
nDo not leave the lead hanging over the edge of a kitchen table or
worktop. Avoid contact between the lead and hot surfaces.