Culer SOLO User manual

www.culer.com | 1.800.320.6478 | [e-mail]. 1.16.17
CULER SOLOTM and DUETTM
Owner’s Manual
Thank you for choosing CULER!
Please read and save instructions prior to use.
R
Made in USA

This page is intentionally left blank.

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 1
Contents ....................................................................
User Tips.....................................................................
Safety .........................................................................
Use & Operation ........................................................
Care ...........................................................................
FAQ ............................................................................
Troubleshooting...........................................................
Warranty ....................................................................
PAGE
1
1
3
4
6
10
11
12
CULER Evaporative Cooler
AC/DC Power Adapter
Quick Step Guide
Owner’s Manual
COOL. EASY. PORTABLE.
Evaporative cooling is the reduction in temperature resulting
from evaporation. When water evaporates, it takes heat from the
immediate air, leaving that air cooler in the process – like a cool,
refreshing breeze off the ocean on a hot day.
Our personal cooling products cool the air by ash-evaporating
water, naturally reducing the temperature of the airow propelled
from the unit. No longer is there a need to cool an entire house
or area to enjoy cool air. CULER’s unique technology allows you
to direct a cool stream of air where you need it most whether
indoors, outdoors, or even on the go.
Table of Contents
Package Contents
User Tips

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 2
Tips for Optimized Personal Cooling:
• The units are designed for portable, personal cooling, unlike
xed AC that uses chemical refrigerants to reduce the ambient
temperature (temperature on the thermostat) of entire homes and
rooms
• Place the unit at least 3 feet (0.9m) from you and do not block the
cool breeze, as the maximum cooling effect is felt directly in the
stream of airow
• Do NOT use in an enclosed space (small room with closed
windows and doors), as this will increase humidity / moisture and
reduce cooling effect
• Do NOT place on or blowing directly at electronics
• The temperature change of the projected airow will vary
depending on the temperature, humidity and other variables in
your location / application
User Tips
Placement
Table
Table
Table
Table
Table
Table
Window
Entry Way
Legend: Recommended
Placement
=
3 feet (0.9m)
GOOD AREAS
• Open room with air
circulation
• On oor near entryway
• Near open window
• On a table
• Directed towards user(s)
CAUTION: DO NOT COVER UNIT WITH FABRIC
RECOMMENDED
CLEARANCE
• At least 3 feet (0.9m)

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 3
Safety
READ AND SAVE THIS MANUAL FOR FUTURE REFERENCE.
WARNING: To reduce the risk of re, electric shock, or injury:
1. Make sure that the power source complies with the electrical
requirements of the product.
2. Do not use this product with damaged or missing lter(s).
3. If the product is not working correctly, has missing parts, has been
dropped, damaged, or dropped in water, call 1.800.320.6478 or
email [e-mail] for evaluation, adjustment, or repair.
4. To protect against electrical shock, do not immerse unit, plug, or cord
in water or spray with liquids.
5. Keep the power cord away from heated surfaces.
6. Do not operate the product if the unit, power cord, or plug is
damaged in any manner.
7. Do not run the cord under any carpets, throw rugs, runners, or
similar coverings.
8. Do not route cord under furniture or appliances, and place cord away
from trafcked area where it will not be tripped over.
9. Do not insert or allow any foreign objects to enter the intake or
exhaust air openings.
10. Do not block or tamper with the atomizing nozzles, as it may reduce
or impede the product’s performance.
11. With the exception of replacing lters, the item is not intended to
be serviced in the eld. Do NOT open the housing in an attempt to
repair the system, as this may alter the performance and void the
warranty.
12. Disconnect the power cord before moving or performing any
maintenance on the product.
13. This product must be grounded. Plug into an appropriate ground fault
circuit interrupter (GFCI) protected outlet that is properly installed
and in accordance with all local codes and ordinances.
14. Do not hang or mount the product on a wall or ceiling.
15. This product should not be used in potentially dangerous conditions,
such as ammable, explosive, or chemically loaded atmospheres.
16. Do not store outside or near hazardous materials.

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 4
Use & Operation
POWER ON
1. Remove tank cap and ll water
tank with 1 gallon of any
drinkable water (tap, hose,
bottled, or distilled) to the
bottom of the ll basket.
NOTE: Do not overll tank. If you see water
in plastic basket, the tank is overlled.
2. Replace cap and tighten until
fully sealed.
NOTE: Unit will not function properly if cap
is not fully tightened.
3. Plug AC/DC power adapter
supply into the power port on
the unit. Plug the three-
pronged plug into an outlet.
4. Press the POWER button at
the top of the unit to turn on
the ash evaporative cooler.
Green light will illuminate.

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 5
NOTE: The CULER ash evaporative cooler will continue to atomize for a short
time while the unit depressurizes. Be sure to turn off product before unplugging.
POWER OFF
5. Press the FAN button to turn
on fan. Adjust air speed by
pressing button: (high, med,
low) Green light will illuminate.
6. Press the COOL button to
activate atomization. Green
light will illuminate.
7. Adjust the cooling port(s) to
the desired positions up-down
and side-to-side.
Press the POWER button to
turn off. Green light will
turn off.
Use & Operation

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 6
Care
CLEANING & STORING
No Water in System
When Storing
Clean the outside with a soft cloth
and mild soap solution.
NOTE: Do NOT store cooler (or
leave unused) with water in the
system for more than 5 days.
Clean water tank (see page 8
for additional instructions) if an
unpleasant odor is detected or
prior to long-term storage.
Prior to storing, clean the water
tank (see pg. 8), ensure water
tank is empty (see pg. 9), and
untighten cap one full turn to the
left to allow for ventilation to the
water tank. Store the cooler in a
clean and dry place.

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 7
Care
CLEANING WATER TANK
1. Completely drain water tank.
(See Empyting Water Tank on
page 9).
3. Add 1 tablespoon (half a
capful) of vinegar to the water
tank.
4. Replace cap and turn until
sealed. Run until the unit is out
of the water and vinegar
solution.
5. The cooler is clean and ready
for continued operation or long-
term storage.
2. Remove tank cap and ll water
tank with half a gallon of any
drinkable water (tap, hose,
bottled, or distilled).

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 8
Care
EMPTYING WATER TANK
1. Unplug the power supply.
2. Remove the water tank ll cap.
3. Carefully turn the cooler over to
allow water to drain out
4. Replace ll cap and turn until
sealed
5. Plug the cooler in and run the
COOL function until the
atomized water stops

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 9
Care
MAINTENANCE / FILTERS
NOTE: Each cooler has two lters:
One for water:
And one for air:
The lters are located inside the
lter access doors on each side of
the cooler.
It is only necessary to change your
lters if you notice a difference in
the evaporation / performance of
the cooler.
NOTE: Filter style may differ from
image.
NOTE: High mineral count,
calcium, and/or hard water may
reduce the life of the lters.
Although not required, distilled
water may be used to extend the
life of the lters and system.
You can purchase CULER lters
and additonal parts online at:
https://www.culer.com/product-
category/culer-home-parts/.
For more information, tips, and
offers, follow our website, blog,
Facebook, and Twitter pages.
R

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 10
What is the run time with COOL on and how much water
does it take?
SOLO: 10 + hours
DUET: 6 + hours
Both the SOLO and DUET will hold up to 1 gallon of water.
Can it be left outdoors?
It is not recommended to leave your cooler outside when it is
not being used. (Think of it like a portable stereo - you can use it
outdoors, but not recommended to leave outdoors.)
Where can you use the CULER evaporative coolers?
The CULER evaporative coolers were designed to be used both
outdoors and indoors.
What type of water can you ll the cooler with?
You should use any drinkable water (tap, hose, bottled, or distilled).
Does ice water make it colder?
Water temperature does not noticeably impact the cooling
performance.
What happens if the cooler runs out of water?
If the cooler runs out of water, it will simply stop atomizing water. No
harm will be done by operating the cooler without water.
Where is the best place to use the unit?
(See Optimal Operating Placement Image on page 3)
Should there be a certain amount of space around the unit?
Yes, there should be at least 3 feet of space in front of the port.
(See Recommended Clearance image on page 3)
For more FAQs, visit our online FAQs page at https://www.culer.
com/faq.
FAQ

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 11
Troubleshooting
PROBLEM CAUSE CORRECTION
Power button
is not
illuminating
a) POWER button is
in the OFF
position
b) Power cord is not
connected
c) Wall outlet is not
providing power
a) Press POWER button one
time
b) Connect power cord and
press POWER button one
time
c) Find an alternate power
outlet
No air coming
from port
FAN button is in the
OFF position
Press FAN button to activate
(high, med, low)
No atomization
coming from
port
a) COOL button is in
the OFF position
b) Water tank is
empty
c) Tank cap is not
fully tightened
d) Water lter is
clogged
a) Press COOL button
one time
b) Fill tank with water
c) Tighten tank cap
d) Replace water lter
Water
streaming
from nozzle(s)
during
shutdown
Water tank is
overlled
Open tank cap to release
pressure. Drain tank to bot-
tom of ll basket. During next
start up the cooling function
may stream water for a few
seconds until the lines have
been cleared.
Water
streaming
from nozzle(s)
during
operation
Air lter is clogged
Replace air lter - you can
purchase CULER lters
online at: https://www.
culer.com/product-cate-
gory/culer-home-parts/.

www.culer.com | 1.800.320.6478 | [e-mail]
Rev. 1.16.17 12
Warranty
1 YEAR LIMITED WARRANTY
• The CULER evaporative cooler is warranted for one year from the
date of purchase against defects in materials and workmanship. At
our discretion, parts that prove to be defective will either be
repaired or replaced, or the whole product will be replaced. In either
case, a copy of your proof of purchase will be required.
• In case any mechanical or electrical repairs are required during the
warranty period, send your complete product, postage or freight
prepaid to the CULER service location.
• This warranty does not include the air or water lters.
• This warranty applies for only 90 days if this product is ever used for
commercial or rental purposes.
• The serial number, model number, and manufacturing date code can
be found on the label attached to the back of the unit. You should
record these numbers and the date of purchase and keep in a safe
place for future reference.
MODEL NUMBER: ____________________________
MFG DATE CODE: ____________________________
SERIAL NUMBER: ____________________________
DATE OF PURCHASE: _________-_________-_________
PURCHASE FROM: ____________________________
Register your product online at www.culer.com/register.
THANK YOU FOR YOUR PURCHASE!

CULER
2030 Dividend Drive
Columbus OH 43228
Telephone: [phone]
Email: [e-mail]
www.culer.com
R

R