Current SERENE 13G User manual

SERENE AQUARIUM - QUICK START GUIDE
Allow a minimum 3.5" from wall for background
light installation and aquarium maintenance.
Use included leveling device and place on
cabinet top to ensure stand is level.
Adjust cabinet leveling feet if needed. Carefully place aquarium on stand.
Place aquarium cabinet in desired location.
1
2
Place level on glass aquarium edge and conrm
aquarium system is level. Adjust leveling feet
if required.
3
45
6Slide lter tube clips out from under cabinet.
7
IMPORTANT LOCATION INFORMATION!
Ensure oor is level and can support a minimum
of 425 lbs./square inch.
Ensure the power outlet used with your aquarium
is a 120VAC GFCI outlet and rated for 750 watts.
Follow leveling instructions below (it will save
you a lot of work!)
Avoid locations near AC/Heating vents or facing
direct sunlight.
STEP 1: Cabinet & Aquarium Installation
LEVEL = Bubble between two lines
Turn the feet clockwise to raise,
counter-clockwise to lower.

SERENE AQUARIUM - QUICK START GUIDE
Carefully place SERENE light xture, move
towards back (leave room for aquascaping.)
Place background light into back cabinet clips.
Connect LED light to controller (insert then
screw tighten), slide-in background light USB
plug, then connect small audio speaker plug.
Secure both tubes in place.
9
10
Adjust door open/close magnet to ensure
door opens when pushed.
11
12 13
14 15
STEP 2: Filter & Lighting Installation
Install suction and return tubes.
8
Place remote holder to desired location using
3M adhesive.
BACKGROUND
LED LIGHT
AQUARIUM
LED LIGHT
AUDIO
Adjust door hinges if required by turning
hinge adjustment screw.
ADJUST
SCREW
TURN TIP
COUNTER CLOCKWISE
TO MOVE FORWARD