611365 609987 609694
611962
Place on header inside vehicle 610798
To secure fastener
in place press
down on
center stem
until flush
with head of
fastener.
To reuse fastener
push center stem
up then install
fastener
through
shield into
hole.
Push center
of fastener
with vehicle
key.
When center is
depressed
lift fastener to
remove.
See emergency brake release instruction under this panel.
Remove this plastic cover by removing 3 plastic fasteners. Seeillustrations below.
609987
Turntheignitionkeytothe‘N’positionand‘chock’tirestopreventinadvertentmovement.
Turn the ignition key to the ‘OFF’ position, remove key and perform required service
procedures following all Safety Guidelines as outlined in your repair manual.
Flip the RUN-TOW switch to the ‘TOW’ position and move vehicle to the desired location and
park it properly on level ground and chock tires immediately.
In Case of Total Power Loss and the ‘Run-tow’ Switch DOES NOT Release
the Brake to Move the Vehicle :
IF VEHICLE IS INOPERABLE AND NEEDS TO BE MOVED:
Failure to follow these instructions can result in SERIOUS INJURYor DEATH
609694
Failure to follow these instructions can result in SERIOUS INJURY or DEATH
THIS PROCEDURE SHOULD ONLY BE TO CLEAR VEHICLE FROM AN UNSAFE AREA AND BE PERFORMED
ONLY BYQUALIFIED TRAINED PERSONNEL
In Case Of Total Power Loss And The ‘Run-tow’Switch DOES NOT Release The Brake To Move The Vehicle:
Turn the ignition key to the ‘OFF’ position and ‘chock’ tires to prevent inadvertent movement.
Connect ‘Auxiliary Power’ line (3) to ‘Primary Power’ line (1) which will release the brake. THIS WILL
CAUSE THE VEHICLE TO MOVE IMMEDIATELY IF NOT ON LEVELGROUND.
Move vehicle to desired location and park it properly on level ground, chock tires, IMMEDIATELY
DISCONNECT ‘AUXILIARY POWER’ AND RECONNECT ‘PRIMARY POWER’(1, 2) FOR SAFETY
AND TO AVOID BATTERY DRAIN.
Reconnect the Weather Pack Seal (4) to the Auxiliary Power line (3) and perform required service
procedures following all Safety guidelines as outlined in your repair manual.
Identify the ‘Auxiliary Power’ line (3) and remove the Weather Pack Seal (4) from the connector.
Identify the ‘Primary Power’ line (1) connector and disconnect the line (2).
MFD BY: E-Z-GO DIVISION OFTEXTRON INC.
DATE OF MANUFACTURE: MM/YY
GVWR: XXXX LBS. (XXX KGS)
GAWR (Front): XXX LBS (XXX KGS)
GAWR (Rear): XXXX LBS (XXX KGS)
TIRE & RIM DIMENSIONS:
FRONT 205/50-10 10X7 @ 30PSI (207 KPA)-COLD
REAR 205/50-10 10X7 @ 30PSI (207 KPA)-COLD
THIS VEHICLE CONFORMSTO ALL
APPLICABLE FEDERAL MOTOR
VEHICLE SAFETY STANDARDS IN
EFFECT AT THE DATE OF
MANUFACTURE SHOWN ABOVE
VIN XXXXXXXXXXXXXX
TYPE OFVEHICLE: LSV
611233
Windshields do not
provide protection
from flying objects
611233
DO NOT alter or tamper with this unit. Unauthorized modifications can result in
SERIOUS INJURY.
Unauthorized modifications can result in damage to the vehicle and will void
the warranty.
TOWING - Always select ‘TOW’
position before towing
WAIT 30 seconds after reconnecting batteries BEFORE turning key switch to
‘REVERSE’, ‘FORWARD’or ‘NEUTRAL’ positions.
611365
To disable electrical system, turn key switch to ‘OFF’ and remove battery wires.
ALWAYS turn key to ‘OFF’ before disconnecting or reconnecting
battery wires. ELECTRICALARC or BATTERY EXPLOSION can
occur if key is not in the ‘OFF’ position.
(see Owner’s Manual)
611962
LOW SPEED VEHICLE DISCLOSURE
THIS VEHICLE IS CLASSIFIED AS ALOW SPEED VEHICLE
THIS VEHICLE
has a maximum speed of greater than 20 milers per hour, but not
greater than 25 miles per hour;
may be a hazard on the roadways if it impedes traffic;
may subject the driver to citations for impeding traffic;
may not be equipped with such safety features as bumpers, a padded
dashboard, visors and a tamper-resistant odometer; and
may be subject to other restrictions specified by the state or local
jurisdiction in which it is operated.
shall not be operated on a public highway with a speed limit in excess
of the maximum specified by the state or local jurisdiction in which it is
operated;