Cygnett CHARGEUP BOOST User manual

CHARGEUP BOOST
2nd Generation 10K
USER MANUAL
This symbol on the product indicates that this product
shall not be treated as household waste. Instead it shall
be sent to the applicable collection point for the recycling
of electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health. For more information about the recycling of this
product, please contact your local city oice.
Caution
Please read all warnings for your safety and optimal user
experience. Please read and follow these instructions
carefully and retain for your records.
1. Disposal of a battery into ire or a hot oven, mechanically
crushing or cutting of a battery, can result in an
explosion.
2. Leaving a battery in an extremely high temperature can
result in an explosion or the leakage of lammable liquid
or gas.
3. A battery subjected to extremely low air pressure may
result in an explosion or the leakage of lammable liquid
or gas.
4. The power bank will generate heat when charging.
Always charge in a well-ventilated area. Do not charge
under pillows, blankets or on lammable surfaces.
5. Keep the power bank away from heat sources, direct
sunlight, combustible gas, humidity, water or other
liquids.
6. Do not disassemble, open, microwave, incinerate, paint
or insert foreign objects into the power bank.
7. Do not subject the power bank to mechanical shock
such as crushing, bending, puncturing or shredding.
Avoid dropping or placing heavy objects on the power
bank.
8. Do not short circuit the power bank or store it in a
receptacle where it may be short circuited by other
metallic or conductive objects.
Caution
9. Do not operate the power bank if it has been wet
or otherwise damaged, to prevent against electric
shock, explosion and/or injury. Contact the dealer
or authorized agent.
10. Usage of power bank by children should always
be supervised.
Please note that changes or modiications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment. Cygnett
takes no responsibility for damages caused by incorrect use
of its products. Made in China.
Cygnett is a trademark of Cygnett Pty Ltd. Made in China.
Cygnett Pty Ltd
858 Lorimer Street, Port Melbourne,
Victoria, 3207, Australia
Cygnett UK Limited
7175 Shelton St, London,
WC2H 9JQ
Cygnett USA Inc
3838 W Carson St, Ste 220, Torrance,
CA 90503
Cygnett EU
Oice 2, Goudstraat 65,
2718RD Zoetermeer, The Netherlands
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to connect
the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Charge Your Device
Recharge your device(s) by connecting a compatible cable
into the USBA output(s) (C/D) and/or USBC output (E).
Press the power button (A), and your device(s) should begin
to charge. When you are inished charging your device(s),
remove the cables from your power bank, and it will turn o
automatically.
To check the remaining charge on your power bank, press
the power button (A) once. The LED battery indicator (B) will
showing the remaining charge from 0 to 100.
Recharge Your Power Bank
To recharge your power bank, use the included USBC to
USBA cable, and connect the USBA into a compatible USBA
charger, then insert the USBC connector into the USBC input
(E). Alternatively, use a USBC to USBC cable and a USBC
charger. When recharging, the LED battery indicator (B) will
lash, indicating the remaining charge.
Product Specifications
B
A
C
D
E
APower button
BLED battery indicator
CUSBA output
DUSBA output
EUSBC input & output
Name ChargeUp Boost
2nd Generation 10K
Item Number
CY3477PBCHE
CY3478PBCHE
CY3479PBCHE
CY3480PBCHE
CY3575PBCHE
USB-A Output 1 5V⎓2.4A (12W)
USB-A Output 2 5V⎓2.4A (12W)
USB-C Output 5V⎓3A (15W)
USB-C Input 5V⎓3A (15W)
Total Output 15W Max