MANUAL
1. LOCK:
Press the lock button 🔒on the remote control, the lights will blink once, and the door
will lock. The LED will start blinking
2. UNLOCK:
Press the unlock button 🔓on the remote control, the lights will blink twice and the
door will unlock. The LED will stop blinking.
3. ROLLING UP WINDOWS (COMFORT FUNCTION):
After pressing the lock button 🔒on the remote control, a 25-second pulse for rolling up
windows will appear at the “comfort” output.
4. FINDING YOUR CAR IN A PARKING LOT
When the car is locked, press the lock button 🔒on the remote control once. The lights
will start blinking for 30 seconds to help you find your car. Pressing the same button
once again stops this function.
5. ADDITIONAL CHANNEL (OPENING THE CAR BOOT)
Press and hold the unlock button 🔓for 2 seconds. A pulse for controlling the car boot
will appear at the output of the additional channel.
6. SETTING THE ELECTRIC/PNEUMATIC LOCK
(using a jumper)
J3: set in position 2. 0.5-second pulses for an electric lock.
J3: set in position 1. 3.5-second pulses for a pneumatic lock.
7. PAIRING REMOTE CONTROLS
You can pair up to 6 remote controls with the controller.
Press once the switch located on the control unit central board, accessible from the side
opening of the housing. The hazard warning lights will switch on. Next, press one of the
buttons on the remote control you want to pair and the hazard warning lights will switch
off. The pairing procedure is now finished. To pair another remote control device,
repeat the procedure.
8. UNPAIRING REMOTE CONTROLS
Press and hold for 3 seconds the switch located on the control unit central board, ,
accessible from the side opening of the housing. The hazard warning lights will blink 5
times. All remote controls are now unpaired.
