CYPRES CapSense User manual

CY3280-BBM UNIVERSAL CAPSENSE®PROTOTYPING MODULE KIT
QUICK START GUIDE
Introduction
1. The CY3280-Bread Board module kit
connects to any CY3280 Universal
CapSense Controller (UCC) board,
such as the latest CY3280-20x66 DVK.
This helps in evaluating the various
PSoC features.
Board Setup
1. Connect the CY3280-BBM board to the
P2 connector of any Universal CapSense
Controller (UCC) board such as the
CY3280-20x34 (to be purchased
separately).
Board Setup
2. The CY3280-BBM provides access to
every pin routed to the 44-pin connector
on the attached UCC board.
3. Use the prototyping area (described in
Step 4) to evaluate the PSoC features.
Module Description
1. The vertical holes on the bread board
from A to H, B to C, G to F, and D to E
are shorted; the horizontal holes from A
to B, H to C, G to D, and F to E are
isolated from each other.
2. To bring out port pins, connect the port
pin headers on to the bread board with
wires.
1 2
3
A
D
G
C
H
FE
B
4

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. DOC#: 001-43368 REV. *A
www.cypress.com/go/CY3280-BBM
For the latest information about this kit, visit
CY3280-BBM UNIVERSAL CAPSENSE®PROTOTYPING MODULE KIT
QUICK START GUIDE
CY3280-BBM Board Details
44-Pin
Connector (J1)
Optional I2C EEPROM
Footprint
Optional Regulator
Footprint
Prototype Area
Optional Second
Connector (J2)
Port Pins
Port Pins