Cypress CAPSENSE CY3280-28 Series User manual

CY3280-28XXX UNIVERSAL CAPSENSE™ CONTROLLER DEVELOPMENT KIT
QUICK START GUIDE
This kit needs to be plugged into the CY3280-SLM Linear Slider Module Kit to get started.
For information on CY3280-SLM, visit www.cypress.com.
Install Software
Install Software PSoC Programmer and
PSoC Designer
Kit Setup
• Connect the CY3280-SLM Module with the
CY3280-28XXX Board
• Place shunts on pins 2 and 3 of JP1 and pins
1 and 2 of JP4 of CY3280-28XXX Board
• Place shunt on pins 2 and 3 of JP2 on
CY3280-SLM module
Program the Board
• Connect your computer to the CY3280-28XXX
by the PSoC MiniProg and a USB cable
• Program the board with the file
CY3280_28XXX_SLM.hex on the CD
• Power on the board with external power
supply
Test the Board
• Touch one or more buttons with your finger
• The LEDs light up corresponding to the buttons
being pressed
1
2
3
4
[+] Feedback

© 2010 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. DOC#: 001-57454 REV **
www.cypress.com/go/CY3280-28XXX
For the latest information about this kit visit
CY3280-28XXX UNIVERSAL CAPSENSE CONTROLLER DEVELOPMENT KIT
QUICK START GUIDE
CY3280-28XXX Universal CapSense Controller Board
CY3280 CPM1 Board Connector
Voltage Test
External INT
SPI/I2C Interface
Selection
ISSP
VCC Select Jumper
Power Supply
ICE Interface
UART Interface
CY3280 SLM
Board Connector
[+] Feedback