Cypress CYUSB3ACC-004A User manual

CYUSB3ACC-004A (INTERCONNECT BOARD FOR
ON SEMICONDUCTOR IMAGE SENSOR) QUICK START GUIDE
1. Connect the EZ-USB®FX3TM SuperSpeed Explorer Kit (CYUSB3KIT-003)
to the ON Semiconductor Image Sensor Interconnect Board
(CYUSB3ACC-004A)
2. Connect the ON Semiconductor Image Sensor Board
(MT9M114_55CSP_HB_DEMO3_REV0) to the CYUSB3ACC-004A Board
Note : CYUSB3KIT-003 and ON Semiconductor Image Sensor Board
(MT9M114_55CSP_HB_DEMO3_REV0) are not part of this kit

CYUSB3ACC-004A (INTERCONNECT BOARD FOR
ON SEMICONDUCTOR IMAGE SENSOR) QUICK START GUIDE
3. Set the Jumpers on the boards as shown below
ON Semiconductor Image Sensor Board
(MT9M114_55CSP_HB_DEMO3_REV0)
4. Learn to use FX3 in applications involving image sensors with the
application note AN75779 - How to Implement an Image Sensor Interface
with EZ-USB®FX3TM in a USB Video Class (UVC) Framework available at
www.cypress.com/AN75779. Refer to sections 6 to 8 for the instructions
to stream video from the Image Sensor to a PC using FX3
© 2019 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the
properties of their respective owners. Doc.#: 002-26891 Rev **
For the latest information about EZ-USB FX3 SuperSpeed Explorer Kit
(CYUSB3KIT-003) and to download Kit Software and Hardware les,
visit www.cypress.com/SuperSpeedExplorerKit
For the latest information about this interconnect board and to download the
hardware les, visit www.cypress.com/CYUSB3ACC-004A
Note:
Please take care when removing the
interconnect board from the SuperSpeed
Explorer Kit board
The suggested removal method is
shown in the picture. Hold the
interconnect board and use a rocking
motion to separate the boards safely
Jumper/
Header No.
Jumper/
Header Name Jumper Setting
P1
P2
P4
P5
P6
P7
P8
P11
P15
P32
1-2
2-3
Open
1-2
1-2
2−3
Open
Closed (A1 column)
1−2 & 3−4
3−5 & 1−2
OE_L
CONFIG
FLASH
TRST
SADDR
+VDDIO
UART
EEPROM
I2C connector
CLOCK SELECTION
Cypress EZ-USB FX3 Superspeed
Explorer Kit (CYUSB3KIT-003)
Jumper/
Header No.
Jumper/
Header Name
Jumper
Setting
J2
J3
J4
J5
Closed
Closed
Closed
Open
VIO1_3
VBUS_JUMPER
PMODE
SRAM_ENABLE