Cypress FM4 S6E2CC PIONEER KIT User manual

FM4 - 176LS6E2CC - ETH QUICK START GUIDE
FM4 S6E2CC PIONEER KIT
Kit Contents:
1 FM4 S6E2CC Pioneer Board
2 USB Standard -A to Micro -B cable
3 Quick Start Guide (this document)

FM4 S6E2CC PIONEER KIT
FM4 - 176LS6E2CC - ETH QUICK START GUIDE
1 2
• Download the port viewer
Terminal (page 3) and install it.
• Download CMSIS - DAP rmware
Package and install the driver.
• Launch the Port viewer Terminal.
Congure the baud rate as115200, and
Click the“Disconnected” to connect
• Press "Enter" on your PC keyboard to run
the board test demo. Key in the option
number and press Enter to run the function.
3
• Connect the board with PC
via CN2 using the USB cable.
4
5

FM4 - 176LS6E2CC - ETH QUICK START GUIDE
Download IDE from:
IAR Embedded Workbench - http://www.iar.com
Keil µVision IDE - http://www.Keil.com
For the following documentations and software:
User Manual
Schematic
Peripheral Driver Library (PDL)
Port Viewer Terminal
Software labs
CMSIS - DAP rmware (on -board ICE)
USB DIRECT (ash programmer)
Please Visit http://www.cypress.com/fm4 176Is6e2cceth

1. Cypress FM4 MCU S6E2CCAJ0A
2. CMSIS - DAP Unit
3. Cypress 256Mb SRAM
4. Ethernet PHY and RJ45 connector
5. USB Device connector
6. Cypress 32Mb Quad - SPI Nor ash
7. Accelerometer
8. Phototransistor
9. Stereo Codec
10. USB host connector
11. RGB LED
12. User button
13. Reset button
14. Ardunio interface (CN7~CN10)
15. Multicon connector
16. 10Pin JTAG connector
17. J1 MD0 Jumper of MB9AF312K
18. J2 MD0 Jumper of FM4
19. CN5 Jack for headphone
20. CN11 Jack for Microphone
21. CN6 Jack for Linein
22. Free-Pin headers (CN15~CN18)
23. J4 Power supply resource select
24. J3 Serial programming mode select
FM4 S6E2CC PIONEER KIT
© 2015 - 2017 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-09738 Rev*A
FM4 - 176LS6E2CC - ETH QUICK START GUIDE
Arduino Uno R3
FM4 Pioneer Kit