Cypress CY3250-29XXX User manual

CY3250-29XXX
What comes with the kit:
• Two 29XXX Pods
• Two 28-pin Masks
• Two Thumbscrews and Compression Plates
ICE Cube shown in the picture is included in CY3215-DK

The CY3250-29XXX emulation pod is designed to work with the PSoC®ICE Cube
(In-Circuit Emulator). The pod requires pod feet that match your Cypress part foot-
print. The ICE Cube (CY3215-DK kit), pod feet, and CY3250-FLEXCABLE can be
purchased separately from the Cypress Online Store at www.cypress.com.
Getting Started
1. Solder one of the emulation pod feet to your target board in place of the
Cypress CY8C29xxx part.
2. Connect the larger end of the CY3250-FLEXCABLE to the ICE Cube emulator.
Ensure that power is being supplied to the ICE Cube. Also, ensure that the ICE
Cube is connected to your host PC via a USB cable provided with the CY3215-
DK In-Circuit Emulator Debugging Kit.
3. Connect the smaller end of the CY3250-FLEXCABLE to the pod as shown on
the front side of this card.
4. Secure the flex cable to the pod using the included compression plate and red
thumbscrews.
5. Connect the pod to the foot previously soldered to your target board, making
sure the pins align correctly using the pin 1 indicators on the pod and foot.
6. Open the PSoC Designer applicationA, which is included on CD as part of the
CY3215-DK kit, and create a firmware project using the appropriate device.
7. To begin debugging your firmware project, follow the instructions within the
PSoC Designer application.
For more information about the CY8C29xxx device, visit us at www.cypress.com.
There you will find data sheets and application notes. For application support, visit us
at www.cypress.com/go/support.
A. Update to the latest PSoC Designer™ including service pack releases at:
http://www.cypress.com/psocdesigner
Mask
29XXX Pod
Thumbscrews and Compression Plates
© Cypress Semiconductor Corporation, 2010. All rights reserved. PSoC is a registered
trademark and PSoC Designer™ is a trademark of Cypress Semiconductor Corp. All
other trademarks or registered trademarks referenced herein are the property of their
respective owners. The information contained herein is subject to change without
notice. Doc. # 001-65200 Rev. **