Cypress S6SBP401AJ0SA1001 User manual

S6SBP401AJ0SA1001 Features:
• Input voltage range: 4.5 V to 5.5 V
• 6-CH output PMIC for automotive ADAS
• Factory-preset output voltage
• Built-in Switching FETs up to 3 A
• Switching frequency: 2.1 MHz (Typ)
• Load-independent Soft-Start
• Size: 3.048 cm × 4.572 cm
S6SBP401AJ0SA10016-CHAUTOMOTIVEADAS
PMICEVALUATIONKIT
DD1 output capacitors
(C40, C2, C3, C6)
DD2 output capacitors
(C41, C8, C9, C10, C14)
DD2 inductor (L2)
DD1inductor (L1)
VREG capacitor (C34)
VCC capacitor (C33)
DD2 input capacitors
(C36, C7)
S6BP401AJ0SN1B000
(M1)
DD3 input capacitors
(C37, C15)
DD3 inductor (L3)
DD4 inductor (L4)
DD3 output capacitors
(C20, C17, C16, C42)
DD4 output capacitors
(C26, C22, C23, C43)
DD4 input capacitors
(C38, C21)
DD1input capacitors
(C35, C1)
LD1 output capacitor (C28)
PG pull-up resistors
(R5, R6, R7, R8, R9, R10)
LD1 input capacitor (C27)
LD2 input capacitor (C30)
LD2 output capacitor (C31)

S6SBP401AJ0SA1001 6-CH AUTOMOTIVE ADAS
PMIC EVALUATION KIT
*Do not supply power to VIN until the setup is completed.
For the latest information about this kit and hardware les,
visit www.cypress.com/S6BP401AJ0/Kit-User-Guide
VOUT1 (1.250 V)
VOUTL1 (3.300 V)
VOUT2 (1.250 V)
GND
VIN (5 V)
EN1
EN2
EN3
EN4
ENL1
ENL2
VOUT3 (1.850 V)
VOUTL2 (2.800 V)
VOUT4 (3.375 V)
Setup*
1 Connect VIN to a power supply and GND to the ground.
2 Connect EN1, EN2, EN3, EN4, ENL1, and ENL2 to VIN.
3 Connect each output, VOUT1, VOUT2, VOUT3, VOUT4, VOUTL1,
and VOUTL2 to a voltmeter.
Check*
1 Apply 5 V to VIN.
2 Each output voltage should be as shown in the gure above.
© 2017 Cypress Semiconductor Corporation, All rights reserved.
All trademarks or registered trademarks referenced herein are the
properties of their respective owners. Doc.# 002-19646 Rev.**