Cypress CapSense Express CY3218-CAPEXP2 User manual

CY3218-CAPEXP2 CAPSENSE®EXPRESS™ EVALUATION KIT
QUICK START GUIDE
1. Insert the AAA battery.
2. Remove the jumper from J2.
3. Observe that the Power LED
lights up.
1. Observe that the status LED D5
flashes.
2. Slide the finger over the
CapSense slider to light up the
respective LED.
Insert the kit CD and run the CD’s
autorun utility.
Open the guide and install PSoC
Programmer and PSoC Designer.
1
2
3
4

© 2009-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. Doc.#: 001-44863 Rev. *E
http://www.cypress.com/go/CY3218-CAPEXP2
For the latest information about this kit, visit
CY3218-CAPEXP2 CAPSENSE EXPRESS EVALUATION KIT
QUICK START GUIDE
Top View Bottom View
Status LEDs
Mechanical Button
CapSense Slider Power Selection Jumper (J2)
Power LED CapSense Express
AAA Battery Holder (J1)
I2C Header (J5)