Cypress CY3642 User manual

QUICK START GUIDE
CY3642 PROGRAMMING KIT
Kit Contents:
1. CY3642 Programming Board
2. USB Standard-A to Mini-B cable
3. Quick Start Guide (this document)
4. IC CY29422FLXI
(placed inside the socket)
The CY3642 Programming Kit enables quick and easy Programming of Cypress’s
High Performance Programmable Oscillator (CY29421, CY29422)
• Download and install the latest kit software onto
your PC from www.cypress.com/CY364X
• Connect the board to your PC using the provided
USB cable
• The Status LED (Green) turns ON after the kit
driver enumeration is complete
1
Steps to successfully program the clock device using
this Programming kit.
• Ensure default Jumper setting as mentioned in
Table overleaf
• Run the Clock Programmer software tool
1. Select CY294xx from the Device List
2. Select 0x55 for target I2C address
3. Click Connect
4. Open the JEDEC le from <Install_Directory>
\CY364x Programming Kit\<version>\Firmware\
CY3642\CY3642 Kit LVPECL 2.5V 156.25MHz)
5. Click Program
• While eFuse programming is underway you
will notice Power LED (LED2) to glow Amber
2

QUICK START GUIDE
CY3642 PROGRAMMING KIT
© 2017 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-18657 Rev.*A
CY3642 Board Details
Kit Contents:
1. CY3642 Programming Board
2. USB Standard-A to Mini-B cable
3. Quick Start Guide (this document)
4. IC CY29422FLXI
(placed inside the socket)
Table: Jumper Default Position
Purpose
Power on CY29422
Jumper
J1
Default
Position
1 - 2
Main Power Supply Jumper (J1)
Power LED
* Component is on the bottom-side of the Programming Board
USB Mini-B
Connector
Status LED
PSoC 5LP
(CY8C5868LTI-LP039)*
Pin-1
Socket for 8-pin LCC 5mm x 3.2mm