D-Link DVG-2101sp User manual

gotalk DVG-2101sp Setup Guide
17/02/2009
Page 1 of 6
D-Link DVG - 2101sp ATA Setup Guide
With PSTN Lifeline
Light is on when
device is powered
up
Light is on when
the VoIP account
is registered
Light is on when the
phone is in use
Light is on if
PSTN Lifeline is
in use
Light is on when
the Ethernet cable
is connected
Light is on when
Provisioning is
taking place
All manuals and user guides at all-guides.com
all-guides.com

gotalk DVG-2101sp Setup Guide
17/02/2009
Page 2 of 6
Continue below fo VoIP configu ation guide
 Pick up the handset attached to the DLink ATA and dial *666#
 P ess 2 on the phones keypad
 P ess 1 to hea the DHCP IP add ess to ente into the web b owse to get to the ATA configu ation
page
RJ phone cable
to “Phone” or
“Line” port of the
Filter/splitter
RJ Phone
cable to the
Phone used to
make VoIP calls
Ethernet cable
to LAN port of
Modem/Router
Power cable
All manuals and user guides at all-guides.com

gotalk DVG-2101sp Setup Guide
17/02/2009
Page 3 of 6
 Log in to the web GUI by ente ing into a web b owse http://192.168.1.150 (example only, use the
add ess p ovided above by dialing *666# 1 2)
 You will see the following page log in page
 Ente the use name as “admin”
 Passwo d emains Blank
All manuals and user guides at all-guides.com

gotalk DVG-2101sp Setup Guide
17/02/2009
Page 4 of 6
 On the left hand side menu select “VoIP”
All manuals and user guides at all-guides.com

gotalk DVG-2101sp Setup Guide
17/02/2009
Page 5 of 6
 This will take you to the “VoIP Account settings page”
 Ensu e the settings in the device match the above image
 Ensu e “use domain to register” has a tick in the box
 Click “Apply” and the VoIP is eady to use, the device does not need to be est afte clicking “Apply”
All manuals and user guides at all-guides.com

gotalk DVG-2101sp Setup Guide
17/02/2009
Page 6 of 6
Changing codecs
 On the top headings, select “Advanced”
 Then on the left hand side menu select “VoIP” and hove the mouse until the d op down list appea s,
then select “Codec” f om the d op down list
As shown in the image below
 Select the codec you wish to use and click “Apply” at the bottom
All manuals and user guides at all-guides.com
all-guides.com