D-Link DI-304 Service manual

D-Link (Europe) Ltd.
4th Floor
Merit House
Edgware Road
London NW9 5AB
U.K.
Tel: [phone]
Fax: [phone]
www.dlink.co.uk ftp//:ftp.dlink.co.uk
Page 1
TECHNICAL BULLETIN
DI-304 Installation Guide for LAN –Internet
1. Introduction
This document explains how to connect to the Internet using a single user account from an Internet Service
Provider. The IP network is a private network and is chosen by the installer. In the example below the private
IP network is 192.168.0.xxx. The service provider may either provide you with a static IP address or more
often a dynamic IP address, that is to say the IP address is assigned to the router at connection time. A local
network IP address still needs to be assigned to the router.
It is assumed the network is already configured and working in terms of network adapters and drivers installed
and configured.
Fig 1.
PC1
PC2
PC3
PC4
The DI-304 does not have a console port for configuration purposes, you must use your windows browser to configure
the DI-304. The router has a default IP address of 192.168.0.1
DI-304
Example Setup Configuration
DI-304 IP 192.168.0.1
PC1 IP DHCP
PC2 IP DHCP
PC3 IP DHCP
PC4 IP DHCP
Subnet for all DHCP
devices
Default Gateway 192.168.0.1
(All PC's)
Internet

Copyright D-Link Europe Technical Support
All trademarks acknowledged
Page 2
Ensure you PC’s are setup to receive there IP address from a DHCP server. (DI-304 in this case). You will also need to
check and ensure your not running any other DHCP server in network see below.
2. Information required from the ISP.
A certain amount of information is required from your ISP. See list below.
IP address (only for static IP address connections)
Username
Password
ISDN Telephone number to dial
DNS (consists of primary domain name controller IP, and name)
3. Router Configuration
After you have setup your PC to receive an IP address from DHCP server, it should have 192.168.0.100 as its IP
address. The router will be 192.168.0.1. Use your browser and connect to the DI-304.

Copyright D-Link Europe Technical Support
All trademarks acknowledged
Page 3
Fig 2 Router main menu.
Fig 3. Router Ethernet Setup
The router defaults to using 192.168.0.0 as the network. DHCP addresses range 192.168.0.100-200. Change these
default setting if you need to. See Fig 3. above.

Copyright D-Link Europe Technical Support
All trademarks acknowledged
Page 4
Fig 4. Router ISDN Setup.
Setup the country code and the router’s own ISDN number as in fig 4.
Fig 5. Internet Setup
From the menu in fig 5 select dialling to a single ISP.

Copyright D-Link Europe Technical Support
All trademarks acknowledged
Page 5
Fig 6. ISP details
Enter your ISP details. For PPP authentication leave the PAP or CHAP setting as the router will negotiate either at
connection time. In the link type, select 64k, 128k or BOD.
After the OK button is selected, you can go to the diagnostics and perform a connection tests.

Copyright D-Link Europe Technical Support
All trademarks acknowledged
Page 6
Fig 7. Diagnostics
Select the Dial ISDN, you should see the ISP name typed in fig 6 appear in the activity, see fig 8.

Copyright D-Link Europe Technical Support
All trademarks acknowledged
Page 7
Fig 8. Diagnostics Result.
~ End of Document ~