D-Link DWM-312W User manual

Quick Installation Guide
DWM-312W
4G LTE Wireless M2M Router with one module
for two SIM c rds

DWM-312W Quick Installation Guide
BEFORE YOU BEGIN
Delivery Package
•Router DWM-312W
•Power adapter DC 12V/1A
•“Quick Installation Guide” (brochure)
•Two detachab e LTE/3G antennas
•One detachab e Wi-Fi antenna
•Mounting kit (optiona ).
If any of the items are missing, p ease contact your rese er.
The “Quick Installation Guide” document is avai ab e on D-Link website (see
www.d ink.ru).
!Using a power supply with a different voltage rating than the one
included will cause damage and void the warranty for this product.
2

DWM-312W Quick Installation Guide
Default Settings
Do ain na e of device dlinkrouter.local.
IP address of device 192.168.0.1
Userna e (login) admin
Password admin
Na e of wireless network (SSID) DWM-312W
Network key (PSK password)
see WPS PIN on the barcode
abe on the bottom pane of
the device
!
Router DWM-312W with defau t settings cannot connect to the
Internet. To get started, p ease set your own password for access to the
web-based interface and change the WLAN name (SSID); then, if
needed, configure other settings recommended by your ISP.
3

DWM-312W Quick Installation Guide
System Requirements and Equipment
•A computer with any operating system that supports a web browser.
•A web browser to access the web-based interface of the router:
◦App e Safari 8 and ater
◦Goog e Chrome 48 and ater
◦Microsoft Internet Exp orer 10 and ater
◦Microsoft Edge 20.10240 and ater
◦Mozi a Firefox 44 and ater
◦Opera 35 and ater.
•A NIC (Ethernet or Wi-Fi adapter) to connect to the router.
•An 802.11b, g, or n Wi-Fi adapter to create a wire ess network.
•An active SIM card (when it is necessary to connect to the Internet via
mobi e operators' networks).1
1 Contact your operator to get information on the service coverage and fees.
4

DWM-312W Quick Installation Guide
Product Appearance
Front Panel
Connectors and Buttons
Na e Description
MAIN An SMA connector for the primary detachab e LTE/3G
antenna2.
SIM A / SIM B S ots for SIM cards used for the primary and auxi iary mobi e
connections.
RESET
A button to restore the factory defau ts.
To restore the factory defau ts, push the button (with the
device turned on), ho d it for 10 seconds, and then re ease the
button.
AUX An SMA connector for the auxi iary detachab e LTE/3G
antenna2.
2 Inc uded antennas are interchangeab e.
5

DWM-312W Quick Installation Guide
LED Indicators
LED Mode Description
SIM A / SIM B
Solid green The LTE WAN connection is on.
Blinking green 2G/3G WAN connection is on.
No light No SIM card is insta ed or the
network mode is undefined.
SIGNAL
Solid green The active SIM card signa strength
is above 50%.
Solid red The active SIM card signa strength
is be ow 50%.
No light The active SIM card is not insta ed
or is b ocked.
INTERNET
Solid green The defau t WAN connection is on.
Blinking green The defau t WAN connection is
active.
Solid red
The defau t WAN connection is off
or there are no WAN connections
created.
No light The WAN cab e is not connected.
PWR
Solid green The router is powered on.
Solid red The router is being oaded.
Blinking green The firmware is being updated.
No light The router is powered off.
In case a LEDs are b inking simu taneous y, the device is in the emergency
mode. Restore the factory defau t settings via the hardware RESET button.
6

DWM-312W Quick Installation Guide
Back Panel
Na e Description
WIFI An SMA connector for the detachab e Wi-Fi antenna3.
WAN/LAN A port to connect to a private Ethernet ine.
LAN An Ethernet port to connect a computer or network device.
Ter inal
block Termina b ock with DI-1, DI-2, DO, Rx, Tx, GND pins.
PWR Power connector.
3 Inc uded antennas are interchangeab e.
7

DWM-312W Quick Installation Guide
CONNECTING TO PC
PC ith Ethernet Adapter
1. Insert a SIM card into the s ot abe ed SIM A on the front pane of the
router with the go d contacts facing down. In necessary, insta a second
SIM card into s ot abe ed SIM B with the go d contacts facing up.
!If you need to connect a SIM card or change it to another one when the
router is powered on, power off the router, insert or change the SIM
card, and power on the router.
2. Connect an Ethernet cab e between the LAN port ocated on the back
pane of the router and the Ethernet port of your PC.
3. Connect the power cord to the power connector port on the back pane of
the router, then p ug the power adapter into an e ectrica out et or power
strip.
Then make sure that your PC is configured to obtain an IP address
automatica y (as DHCP c ient).
8

DWM-312W Quick Installation Guide
Obtaining IP Address Automatically
(OS Windo s 7)
1. C ick the Start button and proceed to the Control Panel window.
2. Se ect the Network and Sharing Center section. (If the Contro Pane
has the category view (the Category va ue is se ected from the View by
drop-down ist in the top right corner of the window), choose the View
network status and tasks ine under the Network and Internet
section.)
3. In the menu ocated on the eft part of the window, se ect the Change
adapter settings ine.
4. In the opened window, right-c ick the re evant Local Area Connection
icon and se ect the Properties ine in the menu disp ayed.
5. In the Local Area Connection Properties window, on the
Networking tab, se ect the Internet Protocol Version 4 (TCP/IPv4)
ine. C ick the Properties button.
9

DWM-312W Quick Installation Guide
6. Make sure that the Obtain an IP address auto atically and Obtain
DNS server address auto atically choices of the radio buttons are
se ected. C ick the OK button.
7. C ick the OK button in the connection properties window.
10