D-Link DSL-2750U User manual

DSL-2750U Wireless Setup Guide
Step 1: Open your Internet browser (ex. Internet Explorer, Mozilla, Google Chrome, Safari) and type in
the Routers IP address in the address bar and press enter. (Default IP 192.168.1.1).
Step 2: Type in the User Account Credentials for the router, then click OK/Log In.
By default the Username is: admin and the Password is: admin
Step 3: On the left side of the screen after successfully logging in, click on Wireless Setup.

Step 4: Wireless Basic Settings
1. Ensure that Enable Wireless is ticked.
2. Enable MultiAP Isolation –un-ticked
3. SSID (Wireless network name) can be changed to whatever you want to call the wireless.
4. Country –South Africa
5. Control Sideband –Upper
6. Wireless Channel –Auto Scan
7. 802.11 mode –802.1b/g/n (default settings)
8. Band Width –20M/40M
9. Click “Apply Changes”.
Note: Router will restart the WLAN (Wireless) after you click “Apply Changes”.

Step 4: Wireless Security Settings
1. Security Mode: Auto (WPA or WPA2) best for iOS devices.
2. WPA encryption: TKIP+AES (Default for WPA or WPA2 setting)
3. WPA Authentication Mode: Auto “(WPA or WPA2) – PSK”
4. Group Key Update Interval: Change to 3600 (Default 1800) for better connectivity when
experiencing intermittency.
5. Pre-Shared Key: must be a minimum of 8 characters
Note: The password will not be visible when entering. Best is to type the password in a
notepad to ensure it is correct.
6. Click “Apply Changes”.
Note: Router will restart the WLAN (Wireless) after you click “Apply Changes”.