DèLonghi HBP532 User manual

We were thinking of you
when we thought of it
HBP 5-12-2000 10:15 Pagina 1

Thermostat
“O” switch “OO” switch
ELECTRICAL CONNECTION
- Before using the appliance check that your supply voltage is the same of that shown on
the rating label of the unit.
- THIS APPLIANCE CONFORMS TO DIRECTIVE 89/336/CEE GOVERNING RADIO
INTERFERENCE, RELATING TO ELECTRO-MAGNETIC COMPATIBILITY.
INSTALLATION
The appliance can be used on any horizontal support surface.
The appliance must not be positioned directly underneath a fixed power
point.
HBP 5-12-2000 10:15 Pagina 2

OPERATION
-Summer use: (ventilation only): turn the thermostat dial fully clockwise to the maximum
position
-Reduced power operation : turn the thermostat dial to the maximum position and
press the “o” switch (the pilot light will turn on).
-Full power operation : turn the thermostat dial to the maximum position and press the
“o” and “oo” switches (the pilot lights will turn on).
-Setting the thermostat:
When the room has reached the desired temperature, turn the thermostat knob slowly in
an anti-clockwise direction until you get to the setting — and not beyond it — until those
lights turn off. The thermostat will then adjust that set temperature automatically and keep
it constant.
Your appliance is the type with 2 switches, you could utilize only one of them during mild
seasons and on days not particularly cold. You will thus use but little electrical power and
obtain even greater savings in energy consumption.
-Anti-freeze function
With the thermostat in the position and the switches pressed, the appliance will
keep the room at a temperature of approximately 5°C, thereby preventing freezing, at a
minimum consumption of energy.
-Switching the appliance off: turn off the switches and turn the thermostat dial anti-
clockwise to the minimum position .
MAINTENANCE
- Always pull the plug out of the power point before cleaning the heater.
- Periodically clean the air intake and outlet grilles during the period in
which the heater is in use.
- Do not use abrasive cleaning products or solvents.
CAUTION
- Do not install the heater in humid environments or near showers, bathtubs, sinks, swim-
ming pools etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (dan-
ger of overheating).
- The heater must positioned at least 50 cm from furniture or other objects.
- When the appliance is used as a portable heater, do not place it close to walls, furnitu-
re, curtains etc.
- The appliance must be installed so that the switches and other controls cannot be reached
from a person standing in a bathtub or a shower.
- Do not cover the appliance when in operation as this could cause a fire risk.
- Do not use the appliance in rooms less than 4 m2in area.
- If the supply cord is damaged, it must be replaced by the manifactured or its service
agents or a similarly qualified person in order to avoid a hazard.
- The appliance is not intended for use by young children or the infirm without supervision
young children should be supervised to ensure that they do not play with the appliance.
The heater is fitted with a safety device which will switch off the heater in case of acci-
dental overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly
or not at all). To reset, disconnect the plug from the power for a few minutes, remove the
cause of overheating then plug the appliance in again.
HBP 5-12-2000 10:15 Pagina 3

New South Wales
P.O.Box 597
Riverwood Sydney, NSW 2210
Customer Service Ph: 02-9793 70441
Fax: [phone]
e-mail: [email protected]
Made in ITALY
Proundly distributed by
Parex Industries Ltd
17 Arwen Place, East Tamaki
Auckland, New Zealand
Customer Service Ph: [phone]
All other departments Ph: [phone]
Fax: [phone]
e-mail:custser[email protected]
HBP 5-12-2000 10:15 Pagina 4