Dacor DOP36M96GL Series User manual

User Manual
Contemporary Gas Pro Range
DOP36M96GL*

English2
WARNING
Never Operate the Top Surface Cooking Section of this Appliance
Unattended.
• Failure to follow this warning statement could result in re, explosion,
or burn hazard that could cause property damage, personal injury, or
death.
• If a re should occur, keep away from the appliance and immediately call
your re department.
DO NOT ATTEMPT TO EXTINGUISH AN OIL/GREASE FIRE WITH WATER.
WARNING: Failure to follow the instructions in this manual exactly may
cause a re or explosion, and, consequently, property damage, personal
injury, or death.
• DO NOT keep or use gasoline or other ammable products near this
appliance.
• IF YOU SMELL GAS:
- DO NOT light any appliances.
- DO NOT touch any electrical switches.
- DO NOT use any phone in your building.
- Immediately call your gas supplier from a neighbor’s phone, and
follow the supplier’s instructions. (If you cannot reach your gas
supplier, call the re department.)
• Installation and service must be performed by a qualied installer,
service agency, or the gas supplier.
ANTI-TIP DEVICE
WARNING
To reduce the risk of tipping the range, the range must be secured
by a properly installed Anti-Tip device. AFTER THE RANGE HAS
BEEN INSTALLED, CONFIRM THAT THE ANTI-TIP DEVICE HAS BEEN
PROPERLY INSTALLED AND VERIFY THAT THE ANTI-TIP DEVICE IS
PROPERLY ENGAGED. Refer to the installation manual for instructions.

English 3
a) If the anti-tip device is not installed, a child or adult can tip the
range and be killed.
b) Verify the anti-tip device has been properly installed and engaged
at the rear right (or rear left) of the range bottom.
c) If you move the range and then move it back into place, ensure
the anti-tip device is re-engaged at the right or left rear of the
range bottom.
d) Do not operate the range without the anti-tip device in place and
engaged.
Failure to do so can result in death or serious burns to children or
adults.
WARNING
Do not step, lean, or sit on the oven door of the range. You can cause
the range to tip, resulting in burns or serious injuries.
Confirm that the Anti-Tip device is installed properly. Then, to verify
that the Anti-Tip device is engaged, grasp the top rear edge of the
range and carefully attempt to tilt it forward. The Anti-Tip device
should prevent the range from tilting forward more than a few
inches.
If you pull the range out from the wall for any reason, make sure the
anti-tip device is properly engaged when you push the range back
against the wall. If it is not, there is a risk of the range tipping over
and causing injury if you or a child stand, sit or lean on an open door.
Never completely remove the leveling legs. If you remove the
leveling legs, the range will not be secured to the anti-tip device
properly.

Contents
English4
Contents
Contents
Before you begin 7
Important 7
Energy saving tips 7
Oven vent/cooling vent 8
Regulatory Notice 9
Important safety instructions 13
Read all instructions before using this appliance 13
Symbols used in this manual 13
California Proposition 65 Warning 14
Commonwealth of Massachusetts 14
General safety 14
Fire safety 15
Gas safety 16
Electrical and grounding safety 17
Location safety 18
Cooktop safety 19
Oven safety 21
Self-cleaning oven safety 22
Usage in high altitude area 22
Overview 23
Layout 23
Display 24
What’s included 25
Using the cooktop 26
Burners 26
Ignition 28
Cookware 30
Grates 32
Wok Ring 33
Using the oven 34
Basic settings – Clock, Date & Time, Language 34
Kitchen timer 35
Timed cooking 37
Delay start 39
Oven functions 40

English 5
Contents
Setting the mode 43
Setting the temperature 43
Basic baking and broiling instructions 44
Using the oven racks 46
Using the gliding rack 49
Using the special function feature 52
Using the healthy cook feature 55
Using the temperature probe 57
Using the clean feature 60
Using the Sabbath feature 64
Using the iQ Control feature 66
To start the oven remotely 67
Child Lock 68
Settings 69
Care and maintenance - Cooktop 73
Cleaning the cooktop surface 73
Stainless steel surfaces 74
Control knobs 75
Burner grates and components 76
Burner caps and heads 77
Burner bases 77
Electrodes 78
Burner head and cap replacement 79
Care and maintenance - Oven 80
Care and cleaning of the oven 80
Removing the oven doors 88
Reinstalling the oven doors 90
Changing the oven light 92
Troubleshooting 93
Information codes 98
Warranty and Service 100
Warranty 100
Open-Source Announcement 103

English6
To Our Valued Customer:
Congratulations on your purchase of the very latest in Dacor products! Our unique
combination of features, style, and performance make us a great addition to your home.
To familiarize yourself with the controls, functions, and full potential of your new Dacor
range, read this manual thoroughly, starting with Before you begin (pg. 7).
Dacor appliances are designed and manufactured with quality and pride, while working
within the framework of our company values. Should you ever have an issue with your
range, first consult Troubleshooting (Pgs. 93 – 99), where you will find suggestions and
remedies that may pre-empt a service call.
Valuable customer input helps us continually improve our products and services, so feel
free to contact our Customer Assurance Team for assistance with all your product-support
needs.
• USA
Samsung Electronics America, Inc.
85 Challenger Road
Ridgefield Park, NJ 07660
• Canada
Samsung Electronics Canada Inc.
2050 Derry Road West, Mississauga,
Ontario L5N 0B9 Canada
Telephone: [phone](USA), 844-509-4659(Canada)
Hours of Operation: Mon – Fri, 8:00 a.m. to 8:00 p.m. Pacific Time
Website: www.dacor.com
Thanks for choosing Dacor for your home. We are a company built by families for families,
and we are dedicated to serving yours. We are confident that your new Dacor range will
deliver top-level performance and enjoyment for decades to come.
Sincerely,

English 7
Before you begin
Before you begin
Important
• The overall design and/or accessories may
differ with the model.
Installer
• To promote safety and minimize
problems, read this manual thoroughly
before starting the installation. Leave
this manual with the user.
• Write the appliance’s model/serial
numbers in this manual for service/
maintenance reference.
User
• Keep this manual for personal reference
and for that of inspectors, service
personnel, etc.
Clean the oven thoroughly before using it for the first time. Then, remove the accessories,
set the oven to Bake, and then run the oven at 400 °F for 1 hour. There will be a
distinctive odor. This is normal.
Ensure your kitchen is well ventilated during this conditioning period.
Energy saving tips
• During cooking, the oven door should remain closed except when you turn food over.
Do not open the door frequently during cooking to maintain the oven temperature and
to save energy.
• If cooking time is more than 30 minutes, you can switch the oven off 5-10 minutes
before the end of the cooking time to save energy. The residual heat will complete the
cooking process.
• To save energy and reduce the time needed for re-heating the oven, plan oven use to
avoid turning the oven off between cooking one item and the next.
• Whenever possible, cook more than one item at a time.

English8
Before you begin
Before you begin
Oven vent/cooling vent
Oven vent
Cooling vent
Oven vent
Both the oven vent and the cooling vent
are located at the back of the oven range.
Proper air circulation prevents combustion
problems and ensures good performance.
• Do not block the vent or its
surroundings with objects.
• Use caution when placing items near
the vent. Hot steam can cause them to
overheat or melt.
• Be careful when operating the oven
whatever the mode it is. The oven lets
very hot air out through the vent.
• Make sure that the oven vent cover
sits securely on the cooktop. You can
verify that the oven vent cover is in
the correct position by confirming that
the tabs on the bottom side of the oven
vent cover fit into the corresponding
slots on the cooktop.

English 9
Regulatory Notice
Regulatory Notice
1. FCC Notice
CAUTION
FCC CAUTION: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of FCC Rules. Operation is Subject
to following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received including
interference that cause undesired operation.
For products available in the US/Canadian markets, only channels
1–11 are available. You cannot select any other channels.
FCC STATEMENT:
This equipment has been tested and found to comply within the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:

English10
Regulatory Notice
Regulatory Notice
• Reorienting or relocating the receiving antennas.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment to an outlet that is on a different circuit
than the radio or TV.
• Consulting the dealer or an experienced radio/TV technician for
help.
FCC RADIATION EXPOSURE STATEMENT:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated so there is at least 8 inches (20 cm) between
the radiator and your body. This device and its antenna(s) must not
be co-located or operated in conjunction with any other antenna or
transmitter.
2. IC Notice
The term IC before the radio certification number only signifies
that Industry Canada technical specifications were met. Operation
is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the
device.
This Class B digital apparatus complies with Canadian ICES-003.
For products available in the US/Canadian markets, only channels
1–11 are available. You cannot select any other channels.