Daema DWP-55 User manual

USER MANUAL
Model
DWP-55/DWP-66
ELECTRIC THERMO POT
BY
D A E W O O E L E C T R O N I C S
SALES & SERVICES ( M ) SDN BHD

TITLES PAGE NO
General Safety Precautions 1
Parts Introduction 3
Technical Specifications 3
Before Using 3-4
How To Use 4-6
Cleaning and Maintenance 6
Trouble Shooting 7
Thank you for choosing DAEMA ELECTRONICS
“ELECTRIC THERMO POT, DWP-55/DWP-66”.
The important information, here, is intended to prevent possible injuries
and damage to the appliance. Please follow accordingly.
General Safety Precaution
Always unplug appliance from the main electrical supply outlet
before cleaning or when not in use.
Always attach the power cord to the appliance BEFORE you plug it
to the main electrical supply.
To disconnect appliance, grasp the plug to remove, do not pull on
the cord.
Close supervision is necessary when operating appliance near
children. Ensure the electrical cord does not hang over the work
surface.
Do not operate appliances with a damaged cord or plug. Any repairs
should be done by an experienced technician or by an authorized
service center.
Always place appliance on a flat steady surface.
When moving the appliance, be cautious and avoid touching hot
surfaces.
Do not immerse appliance or electrical parts in water or any other
liquids.
Use of accessories or equipment not supplied by the manufacturer
may cause damage or malfunctioning of your appliance or result in
injuries.
Not suitable for outdoor usage or in damp areas. This appliance is
for domestic use only.
Do not dispense when boiling.
Do not touch hot surfaces, use handles or knobs.
Never block the stem vent opening.
The unit may not function properly if used in high elevation or in
very cold or hot conditions. In such conditions, unit may keep
boiling or not reach boiling point.
-1-
CONTENTS

Parts Introduction
1. Steam Vent
2. Manual Pump
3. Lid Lock
4. Control Panel
5. Spout
6. Water Level Gauge
7. Empty Mark
8. Pump Lock
9. Upper Lid
10. Handle
11. Power Receptacle
12. Rotating Base
13. Upper Lid Hinge
14. Full Mark
15. Detachable Upper Lid
16. Gasket
17. Water Tank
18. Power Cord
19. Plug
20. Re-boil Button
21. Boil Light Indicator
22. Keep Warm Light Indicator
23. Auto Dispense Button
-2-
Technical Specifications
Model
DWP-55 / DWP-66
Voltage
220-240V~ 50/60Hz
Power
730W
Capacity
5L / 6L
Specifications are subject to change without prior notice with the
development of technology.
Before Using
1. Please read these instructions carefully before using and keep them
for future reference.
2. Check and confirm the local main voltage is the same as stated on
the appliance.
3. Handle power cord carefully. Do not bend or pull on cord. Unplug
from wall socket when not in use.
4. Always use the dispenser in a vertical upright position.
5. Allow dispenser to cool before cleaning.
6. The unit may be deformed or damaged when exposed to heat or
used in unstable surroundings (excess water or humidity.).
7. Boiling without any water in the pot would damage the unit.
8. Avoid touching the outer body during operation. Always allow unit to
cool before handling.
9. Do not immerse power cord or unit in any water or any liquid.
10. Close supervision is necessary when appliance is used by or near
children. Never leave appliance unattended.
11. Do not operate any appliance with a damaged cord or plug or
malfunctions or has been damaged in any manner.
12. Do not attempt to repair the appliance, contact LUCKY.
13. Never use attachments not recommended by the manufacturer.
14. The appliance is not intended for outdoor use or in damp areas.
Household use only.
15. Power cord should not be tangled, left on hot surfaces or allowed to
hang over table edges.
16. Appliance should be given ample air circulation on all sides.
17. An insulated hot pad is recommended on surfaces where heat may
cause problems.
18. Do not use appliance for other then its intended usage.
19. Be cautious of hot steam when opening the top lid.
-3-

20. Point steam away from power point switch and furniture.
21. Keep flammable materials away from appliance.
22. Handle power cord carefully as cord may malfunction if dropped.
23. It is normal for smoke and smell to be emitted during first use, it will
stop after a short period of usage.
24. Be extra careful when moving the appliance filled with hot water.
25. Do not fill above the “Full” water guide mark.
26. Do not cover or block steam vent with cloth or any material.
27. Always ensure the lid is closed properly.
28. Make full use of handle when moving the appliance.
How To Use
HAZARDS
Removing and attaching top lid
1. Pull on lid lock and open lid to about 45-degrees angle and
remove lid from securing hinge.
2. To attach, insert the shaft of the lid into the hinge holder. Close
and press on lid unit it clicks.
Never remove lid while the appliance is operating.
Be cautious of steam when opening lid.
-4-
Using the dispenser for the first time
Wash and rinse inner tank with water.
Fill water up to full line.
Boil once and discard water by pumping it out.
1. Open top lid and add water
Pull up on the lid lock and open top lid.
Fill with cold water from another container, such as a kettle or
pitcher. Do not fill directly under faucet.
To prevent overflow, do not fill above the maximum mark.
Be careful not to splash water onto the control panel.
2. Close the top lid
Carefully close lid by pressing down until a click is heard
Do not close lid forcefully, hot water may gush out and scald.
3. Boiling the water
Unit begins to function (boil) once power is connected.
First attach body plug to receptacle then plug into to wall
outlet.
Never connect power when unit is empty.
When rotating the body, be cautious of the power cord.
4. Reading the control panel
“Boil” light is on during the boiling cycle
Will switch to “Keep Warm” automatically when water is
boiled
Do not open the top lid.
Do not touch the steam vent.
Do not place cloth or other items covering the steam vent.
Do not dispense water while water is boiling.
5. Dispensing water –electric pump
Press the “Dispense” button to dispense hot water
Hot water may not dispense smoothly immediately after
boiling, this is due to air bubbles trapped inside.
Never press the “Dispense” button if dispenser is empty.
Electric dispense will not work if unit is unplugged.
6. Dispensing water –manual pump;
Switch manual pump lock to “Unlock”
Press down on the manual pump
NOTE:
Add water before water level reaches the “Refill” line.
7. Reboil function
Make sure water level is above the “Refill” mark before
reboiling.
Re-boiling a full container takes about 3 minutes.
The re-boil key may not respond right after the water has
boiled. -5-
To protect against electric
shock, do not immerse base,
cord or plug in water or other
liquid.
Do not place on
unstable surfaces.
Only fill with pure water.
Do not put milk, tea, ice or
any other substance into
dispenser.
Do not fill above the maximum level
mark inside the tank or lower than
the minimum level to avoid damage
to the product.
Do not place on or near a hot gas or
electric burner, or a heated oven.

Once the Re-boil button is pressed, the boiling process cannot
be reset until the dispenser automatically switches to Keep
Warm mode.
Do not press the Re-boil button repeatedly as the continuous
boiling process may cause unit to malfunction.
Cleaning and Maintenance
Disconnect power and allow appliance to cool before cleaning.
Disconnect power from wall outlet and remove cord from receptacle.
Detach upper lit and pour out remaining water. Be cautious if water is hot.
Do not wash under running water. Do not place in a dishwasher or dryer.
Do not wet the control panel and receptacle.
Do not leave water in pot unused for long period of time.
Do not turn unit upside-down to dry.
Do not immerse any part of the dispenser in water or any liquid.
Do not use bleach, alcohol or other harsh chemicals
Do not scrub with metal pads or sharp objects.
Upper lid must be detached when pouring out water.
Do not handle plug when hands are wet or damp.
Minerals in tap water may cause white residue to attach to the surface of
the inner tank. They sometimes change the color of the inner tank (reddish
or black). Clean the interior frequently to avoid this problem.
Lid and body
Wipe clean with damp cloth.
Inner pot and inner lid
Use soft sponge to clean and rinse with water. The amount of build-up and stain
depends on the quality of water and times of boiling. The inner pot should be
cleaned once a month. If extremely dirty, use Citric Acid, lemon or lime juice:
Add approximately 1 oz. of the preferred solution.
Add water to the full line, close lid and connect power.
Allow solution to boil and soak for 30~60 minutes.
Dispense a few cups of solution to clean the piping.
Disconnect power and allow unit to cool.
Remove lid and pour out solution, rinse clean.
If lemon was used, to remove the smell of lemon, fill with clean water,
boil and dispose.
DO NOT use: dish soap, scrubbing powder or brush, benzine, thinner
or any harsh chemicals.
When not in use for an extended period of time, clean and let dry
completely before storage. Store in original packaging or plastic
bag and keep in a cool, dry place.
-6-
Trouble Shooting
SYMPTOM
POSSIBLE CAUSE
Water does not boil when plugged
in. (Power LED on)
Dirty inner pot. Added water is already
hot. Water level is below refill line.
Unit will not switch to Keep Warm
Unit may not function properly if used in
high elevation or in very cold or hot
conditions. In such conditions, unit may
keep boiling or not reach boiling point.
Unit will not switch to Boil
Water level is too low. Dirty inner pot
Auto pump does not work or not
working efficiently
Unit not plugged in.
Immediately after boiling, bubbles may
form which makes it difficult to dispense.
Open the lid to release steam.
The interior is dirty and needs cleaning
Water is flowing out from unit
Water is filled above the FULL line.
White substance floating in water
These are mineral deposits. (Not erosion
of inner pot.) Clean the unit according to
the instructions under Maintenance
Boiling sound is excessively loud
Interior is dirty and needs cleaning.
Hot water has unpleasant odor or
taste
Resin used in manufacturing may give off
a mild odor. This will disappear with use.
Due to chlorine in water –reboil the water
Products bearing the crossed out bin symbol are not to
be disposed with your general household waste. For
the correct collection and treatment of these products,
take them to the collection points designated by your
local authority. Alternatively contact the retailer who
sold you the product.
-7-