Daktronics DXB Series User manual

201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
DXB SERIES DIGITAL
BILLBOARD
SERVICE MANUAL
P2177
DD4140427
Rev 01
24 November 2021

Copyright © 2019-2021
All rights reserved. While every precaution has been taken in the preparation of this manual, the publisher assumes no
responsibility for errors or omissions. No part of this book covered by the copyrights hereon may be reproduced or copied
in any form or by any means—graphic, electronic, or mechanical, including photocopying, taping, or information
storage and retrieval systems—without written permission of the publisher.
Daktronics trademarks are property of Daktronics, Inc. All other trademarks are property of their respective companies.
FCC Statement
Supplier Declaration of Conformity (SDoC)
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated
in a commercial environment. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications. Operation of
this equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at their own
expense.
Warning: The user is cautioned that changes and
modications made to the equipment without the
approval of manufacturer could void the user’s
authority to operate this equipment.
Industry Canada Regulatory Information
This Class A digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe A est conforme à
la norme NMB-003 du Canada.
Inquiries
Contact Daktronics with any questions regarding our
product compliance.
Mail:
Daktronics
201 Daktronics Dr.
Brookings, SD 57006 USA
Phone:
800-325-8766
Website:
www.daktronics.com

– i –
Table of Contents
1 Introduction���������������������������������������������������������������������������������������������������������������������������1
Important Contact Information ..........................................................................................................1
Display Identication............................................................................................................................1
Spare Parts.............................................................................................................................................1
Field Replaceable Units .......................................................................................................................2
2 Display and Control Overview ��������������������������������������������������������������������������������������������3
Display Control System Flow Overview ..............................................................................................3
Display Power Overview ......................................................................................................................3
Display Signal Overview.......................................................................................................................3
Even Module High Section Signal Path ������������������������������������������������������������������������������������������3
Odd x Even Module High Section Signal Path�������������������������������������������������������������������������������4
Odd x Odd Module High Section Signal Path �������������������������������������������������������������������������������4
3 Troubleshoot the Display������������������������������������������������������������������������������������������������������5
Remotely Cycle Power ........................................................................................................................5
Troubleshoot the Display......................................................................................................................5
4 Access Internal Components����������������������������������������������������������������������������������������������9
Rear Access ..........................................................................................................................................9
Front Access..........................................................................................................................................9
5 Test and Remove Modules ������������������������������������������������������������������������������������������������10
Module Lanyard Attachment ...........................................................................................................10
Remove a Module (Front Access)....................................................................................................10
Reinstall the Module (Front Access) .................................................................................................10
Remove a Module (Rear Access) ....................................................................................................11
Remove a Fan Plenum.......................................................................................................................11
Remove a Module from Behind a Term Panel or ISP Enclosure....................................................12
Remove the SmartLinkTM For Module Access ..................................................................................12
Reinstall a Module (Rear Access).....................................................................................................13
6 Test and Replace Display Components ���������������������������������������������������������������������������14
Test a Module......................................................................................................................................14
Module Status Indicators ���������������������������������������������������������������������������������������������������������������14
Perform a Module Self-Test������������������������������������������������������������������������������������������������������������14
Replace Module Power Supplies......................................................................................................14
Test and Replace a ProLink Router...................................................................................................15
Test a PLR �����������������������������������������������������������������������������������������������������������������������������������������15
Replace a ProLink Router���������������������������������������������������������������������������������������������������������������16
Replace PLR Power Supplies ���������������������������������������������������������������������������������������������������������16
Replace a Display Fan�������������������������������������������������������������������������������������������������������������������16
7 Control Equipment Overview, Service, and Replacement ��������������������������������������������17
Open the ISP Enclosure......................................................................................................................17
Control Equipment Overview............................................................................................................17
ISP Enclosure �����������������������������������������������������������������������������������������������������������������������������������17
DMP-8000 ����������������������������������������������������������������������������������������������������������������������������������������17

– ii –
Table of Contents
SmartLinkTM �������������������������������������������������������������������������������������������������������������������������������������17
Connect a Laptop .............................................................................................................................17
Replace Control Equipment .............................................................................................................18
Replace the DMP-8000 ������������������������������������������������������������������������������������������������������������������18
Replace DMP/VIP Power Supply���������������������������������������������������������������������������������������������������18
Replace the ISP Enclosure Filter ����������������������������������������������������������������������������������������������������18
Replace the Router�������������������������������������������������������������������������������������������������������������������������19
Replace the Network Switch ���������������������������������������������������������������������������������������������������������19
Replace the SmartLinkTM ���������������������������������������������������������������������������������������������������������������19
Replace the Z-Filter ������������������������������������������������������������������������������������������������������������������������20
Replace the Heater������������������������������������������������������������������������������������������������������������������������20
Replace the Fan �����������������������������������������������������������������������������������������������������������������������������20
8 Test and Replace Multi-Direction Light Sensor ����������������������������������������������������������������21
Test the MDLS ......................................................................................................................................21
Replace the MDLS..............................................................................................................................21
9 Access and Troubleshoot the Webcam���������������������������������������������������������������������������22
Retract the Webcam to the Display Face (Rotation Mount Only)...............................................22
Troubleshoot the Webcam................................................................................................................22
10 Display Maintenance���������������������������������������������������������������������������������������������������������23
Service Calls ........................................................................................................................................23
Annual Inspection ..............................................................................................................................23
Glossary�������������������������������������������������������������������������������������������������������������������������������������24
A Reference Documents �������������������������������������������������������������������������������������������������������25
B Daktronics Warranty and Limitation of Liability ���������������������������������������������������������������27

Introduction
1
1 Introduction
Important Contact Information
Daktronics Customer Service: 1-800-DAK-TRON (325-8766)
Project Manager: Phone Number:
Email: [email protected]
Display Identication
This section provides information
that is helpful in understanding a
Daktronics digital billboard display
label. Refer to Figure 1 while
reading the table below.
Display Assembly Number
Display Serial Number
Manufacture Date
(Day/Month/Year)
DXB-0X00 Modules High X Modules Wide
RMN: Daktronics - 0204 - 09 Manufactured in Sioux Falls, SD
120/208/240 VAC, Single Phase, 60 HZ
AMPS (L1/L2)
Total Watts
Spare Parts
Every Daktronics digital billboard is shipped with spare parts that include commonly
replaced components. The table lists some of the components that may be included in
the spare parts rack. Refer to the spare parts inventory list contained in the bag in the
spare parts rack for a list of the parts. Contact the Account Service Manager (ASM) to
order additional spare parts.
Component Description
Power Supply
Module
Air Filter
4-Pin Mate N Lok Plug
Splice Tool (Sectional Displays Only)
72" SATA Cable
28" SATA Cable
Figure 1: DXB Series Display Label
Table of contents
Other Daktronics Industrial Equipment manuals