dalap MISTY 40 User manual

1
INTRODUCTION MANUAL
Model: TSP40-EA
Mist Fan, 16 Inch
220v-240v,50Hz, 80W
NOTE: Please read the manual carefully before using

1
WARNINGS
ATTENTION : read this booklet carefully it contains important
instructions for a safe installation, use and maintenance.
Important instructions to be kept for future reference.
It is forbidden for the children to play with the device.
This device must be used only for the purpose it was expressly
designed; any use not complying with the instructions contained in the
manual is considered inappropriate and dangerous. The manufacturer
is not responsible for possible damages caused by the inappropriate
and/or unreasonable use.
This device is NOT suitable to use it in an explosive environment (in the
presence of flammable substances such as gas, vapor, mist or dust, in
atmospheric conditions when, after ignition, the combustion is spread in
the air).
The packing materials (plastic bags, expanded polystyrene, etc.) must
be kept out of the reach of children or disabled persons since they
represent potential sources of danger.
The installation/assembly of the device will be made/ or according to the
indications of the manufacturer. A wrong procedure may cause
damages to persons, animals or objects, for which the manufacturer
cannot be considered responsible.
Place and use the device on a horizontal and stable surface.
Before use check the integrity of the device and power cable. In case
you are not sure contact a qualified person.
Before powering the device make sure the rating (voltage and
frequency) corresponds to the grid and the socket is suitable for the
plug of the device.
Make sure the power system is equipped with proper protection
according to the law in force.
DO NOT power the device using multiple sockets.
If possible, avoid the use of adapters and/or extension cables; if their
use is absolutely necessary, use only materials in compliance with the
current safety regulations and according to the electrical parameters of
the adapters.
The device must not be switched on using external timers and/or other
remote control devices which are not specified in this manual.
DO NOT use or store the device near heat sources (heaters, stoves etc.).
DO NOT dip the device in water or other liquids; in case the accidental
fall in the water DO NOT try to take it out, but first of all unplug
immediately the power cable from the socket.
If you use the device for the first time, make sure to remove any label or
protective sheet which blocks its proper functioning.

2
Technical information
If the fan must be stored for a long period and is not used regularly,place the fan in its original packaging in a dry place. When you use it for
the first time after a long period of inactivity, make sure the fan is cleanand the motor blades turn feely (with the device not powered) withoutany restraint.
If the fan must be stored for a long period and is not used regularly,place the fan in its original packaging in a dry place. When you use it forthe first time after a long period of inactivity, make sure the fan is cleanand the motor blades turn feely (with the device not powered) without
any restraint.
1. Misting Board
2. Front Grill
3. Misting Board Lock Screws
4. Blades
5. Blade Lock Nut
6. Back Grill
7. Grill Ring
8. Motor Shaft
9. Motor Cover
10.Connector
11. Main Holder
12. Connection terminal
13. Handle screw
14.control panel
15.body forward shell
16.water tank
17.body rear shell
18.base
19.castor
20.base lock
21.mist pole
22.remote control

3
Assembling the appliance:
- Install the five castors on the base (18).
- Install the body (15) into the base (18) , and use the base lock nut (20) to
screw on the base tightly.
- Connect power connection line (12 ), and put it into the main body (15),
and tight up by holder fixed screw (13).
- Install the back grill (6) , and tight up by grill lock nut (5) on the motor cover
(9)
- Install the blades (4) on to the motor shaft (8), and anticlockwise by blade
lock nut (3).
Installation
- Be sure to remove all packaging material from inside
the appliance.
- Ensure that the fan is switched off from the supply mains before start any
installation or assembly operation.
- The appliance should be used with its base fitted.
- Install misting board (1) on the front grill (2) and screw up by misting board
lock screws (3).
- Put the front grill (2) and back grill (6) together, and screw to fasten by grill
ring,and tight up by grill lock nut.
ATTENTION!
•Make sure the products unplugged from the mains before filling or refelling
the water tank.
•Only use water in the water tank. Do not add any chemicals, oils or other
additives.
•Only use cold or lukewarm water in the water tank. The water must not be
warmer than 40°C.
Place the fan on a dry and stable surface and insert the plug on the
socket; the unit will emit a short “BIP”sound indicating that pow er
is supplied. For your convenience the unit can be operated by using
control panel in the main body or by using remote control included.

4
Operation the appliance:
Control panel Remote Control
Filling water:
- Push the water tank upward and remove the water tank.
- Unscrew the filler cap and fill with water.
- Screw the filler cap and put the water tank back in position.
- CAUTION: The temperature of water should not be 40ºC above.
Operating the ice box:
- Turn off the appliance and pull out plug from the electrical outlet.
- Take out water tank, and then take out the ice box from appliance.
- Put the ice box into refrigerator for freezing
- After freezing, put the ice box on water holder make temperature lower.
- It can be reused.
Operating aroma tank:
- Take aroma case out on the body rear shell.
- Put several drops aroma liquid into the aroma case, and
put the aroma case back in position.
- Slowly the aroma evaporates and be full of room while the mist fan working.
ON/OFF button:
- Firstly push ON/OFF button, the indicator light is on.
- Secondly push ON/OFF button, the wind speed is in the low level by
default. Meanwhile, the indoor temperature shows on the panel.
Thirdly push ON/OFF button, all stop working, all indicator lights off.

5
Speed button:
- Firstly push speed button, the wing speed is in the medium level
- Secondly push speed button, the wind speed is in the high level
- Thirdly push speed button, the wind speed returns to the low level.
Mode button:
- Natural mode →Sleep mode →Normal mode
Natural mode : The wind imitate the blow of natural wind based on strong
and soft wind.
Sleep mode: the first half hour after running as strong and
soft natural wind, it becomes med natural wind and the
second half hour it changes to soft natural wind until the end of preset time.
Normal mode: The wind blow based on Low/Med/High speed.
Mist function:
- Mist function can be used separately, or worked together with the fan.
- Firstly push Mist button, the mist spray in low volume.
Secondly push Mist button, the mist spray in medium volume.
- Thirdly push Mist button, the mist spray in high volume.
- Note: While the mist function work normally, the indicator light on the body
shell is blue, while the water is lacking, the indicator light is red.
plus or minus pole.
Oscillation function:
- The oscillation function makes it possible to direct the flow from the
apparatus so that it automatically alternates
over a range of 75º
- To activate this function, push the OSC button. The yellow light of OSC on .
- Press it again to stop oscillation, yellow light of Osc off. Ionic function:
- Mist function can be used separately, or worked together with the fan.
- The appliance can generate negative ions generated by the ionizer
emanate from the unit throughout the room and cause dust, pollen, pet
dander etc to clump together and drop out of the air.
- Push the ion button, green light of Ion function on,
- Push it again to stop working, the green light of Ion function off.
Mosquito repellent function
- Mosquito repellent function can be used separately, or worked together
with the fan.
- Put the mosquito repellent tablet (not included with the product) into its hole
on the body rear shell.
- Push Mosquito button red light of mosquito repellent on, to avoid the
mosquitoes annoy.
- Push it again to stop working, red light of mosquito repellent off.
Note:

6
- Turn off the power when you replacing the mosquito repellent tablet, wait
for 10 minutes then replacement in order to avoid burns or electric shock.
- Do put the mosquito repellent tablet in contact with eyes or mouth. If put in
mouth by accident, wash mouth and seek medical care immediately.
-Note: While the mist function work normally, the indicator light on the body
shell is blue, while the water is lacking, the indicator light is red.
plus or minus pole.
CLEANING AND MAINTENANCE
NOTED: Before cleaning the appliance always disconnect the power
plug from the receptacle.
1. DO NOT dip the device in water, or splash it with any other liquids.
2. DO NOT use solvents or any other chemical products for cleaning it.
When you do not use it, after cleaning it, store the fan in a dry place.
3. When you have finished using the fan at the end of the season, wipe off
any dust to maintain it in good working order for the next season; if
necessary disassemble the grille and remove the fan; clean them with a soft
damp cloth.
4. Remove the water tank and clean it with lukewarm water; before replace
the water tank in the unit make sure it is completely dry. Draining the water
out of the unit placing a container underneath the water drain (indicated with
an arrow in below picture) and let any water remaining in the water reservoir
drain out.
DISPOSAL
Used electric household devices
Further disposal instructions
1. If you do not want to use your electrical appliance any longer,
return it free of charge to a recycling depot for used electric
appliances.
2. Used electric devices do not belong in the household garbage
(see symbol)

7
1. Return the electrical appliance in such a condition that its later re-use or
recycling is not adversely affected. Batteries must be removed in advance
and the destruction of parts which contain fluids must be avoided.
2. Electrical appliances can contain harmful substances. Improper handling
or damage to the appliance can lead to health problems or water or ground
contamination, when the appliance is recycled later.
SPECIFICATION
Product: Mist Fan
Model: BM22-R
Power: 80W
Voltage: 220V-240V / 50Hz
Made In China
All images serve as illustrations only and do not always show exact
representations of the device.
All rights reserve