Datalogic CM96 Series User manual

Datalogic S.r.l.
Via S. Vitalino, 13
40012 Calderara di Reno (BO)
Italy
Tel. [phone]
Fax [phone]
©2022 Datalogic S.p.A. and/or its affiliates
All rights reserved. Without limiting the rights under copyright, no part of this
documentation may be reproduced, stored in or introduced into a retrieval sys-
tem, or transmitted in any form or by any means, or for any purpose, without the
express written permission of Datalogic S.p.A. and/or its affiliates.
Owners of Datalogic products are hereby granted a non-exclusive, revocable
license to reproduce and transmit this documentation for the purchaser's own
internal business purposes. Purchaser shall not remove or alter any proprietary
notices, including copyright notices, contained in this documentation and shall
ensure that all notices appear on any reproductions of the documentation.
Electronic versions of this document may be downloaded from the Datalogic
website (www.datalogic.com). If you visit our website and would like to make
comments or suggestions about this or other Datalogic publications, please let
us know via the "Contact" page.
Disclaimer
Datalogic has taken reasonable measures to provide information in this manual
that is complete and accurate, however, Datalogic shall not be liable for technical
or editorial errors or omissions contained herein, nor for incidental or conse-
quential damages resulting from the use of this material. Datalogic reserves the
right to change any specification at any time without prior notice.
Trademarks
Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in
many countries, including the U.S.A. and the E.U.
PowerScan is a trademark of Datalogic S.p.A. and/or its affiliates, registered in
the U.S. All other trademarks and brands are property their respective owners.
Patents
See www.patents.datalogic.com for patent list.
This product is covered by one or more of the following patents:
Utility patents: US10915476.
CM96XX
Quick Reference Guide
820123301 Rev. B March 2022
©2022 Datalogic S.p.A. and/or its affiliates • All rights reserved •
Without limiting the rights under copyright, no part of this documen-
tation may be reproduced, stored in or introduced into a retrieval sys-
tem, or transmitted in any form or by any means, or for any purpose,
without the express written permission of Datalogic S.p.A. and/or its
affiliates • Datalogic and the Datalogic logo are registered trade-
marks of Datalogic S.p.A. in many countries, including the U.S. and
the E.U.
www.datalogic.com
Multi Interface
Connection Module
USING CM96XX
The CM96XX connection module is a modular component of the BC96XX
which provides power and communication between the host and the
base station.
It is mainly used as a replacement part for the BC96XX Base Station. The
CM9680 can also be used as an accessory to connect a PD96XX reader
to an Ethernet host.
The available models are:
•CM9630 CONN Model Multi interface
•CM9631 CONN Model Multi Interface IP65
•CM9680 CONN Model Ethernet
CM96XX REPLACEMENT
To replace a CM96xx connection module in a BC96xx base station follow
the steps below:
1. Unscrew the connection module from the cradle.
2. Unlock the lever and remove the connection module from the cradle.
3. Replace the module by inserting it into the cradle, lock the lever and
screw the module to the cradle.
For other base station mounting solutions see the BC96xx Quick Refer-
ence Guide or the PowerScan 9600 Family PRG.
CM9680 Accessory for PD96xx Readers
The CM9680 can be used as an accessory for those who want to use an
Ethernet interface with a PD96XX gun.
TECHNICAL SPECIFICATIONS
ELECTRICAL CHARACTERISTICS
Supply Voltage
When used with BC96XX
CM9630: Host power 5VDC +-5% (*) or 10-30 Vdc +-5%
External power 10-30 VDC +-5%
CM9631: Host power 5VDC +-5% (*) or 10-30 Vdc +-5%
CM9680: External power 5VDC +-5% or 10-30 Vdc +-5%.
When used as a separate accessory
CM9680: External power 5 -30 Vdc +-5%
(*) with approved interface cables
Power Consumption 1.5 A max
Indicators
CM9680:
-BF LED (red/green): network status;
-LINK LED (yellow/green): link activity;
-SF LED (red/green): module status;
-PWR LED (green): power ON (this LED
is not visible when installed in the cra-
dle).
ENVIRONMENTAL CHARACTERISTICS
Working Temperature -20° to +50 °C / -4 to +122 °F
Storage
Temperature -40° to +70 °C / -40 to +158 °F
Humidity 90% non condensing
Protection Class
CM9630 and CM9631 can only be used together with the base
station BC96XX. Refer to BC96XX Quick Reference Guide for
protection class information.
CM9680 used alone as an accessory: IP40
RS232 cable
Mounting screws
position

REGULATORY INFORMATION
All models are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required.
Any changes or modifications to equipment, not expressly approved by
Datalogic could void the user's authority to operate the equipment.
Statement of Agency Compliance
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Class B Compliance Statement
The user is cautioned that changes or modifications not expressly
approved by the part responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device pursuant to part 15 of the FCC Rules. These lim-
its are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following mea-
sures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•Consult the dealer or an experienced radio or television technician
for help.
Canada Notice
This equipment does not exceed the Class B limits for radio noise emis-
sions as described in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la classe
B prescrites dans le Règlement sur le brouillage radioélectrique édicté
par le ministère des Communications du Canada.
Customs Union
The CU conformity certification has been achieved; this allows the Prod-
uct to bear the Eurasian mark of conformity.
Power Supply
This device is intended to be connected to a UL Listed/CSA Certified
computer which supplies power directly to the device or else be supplied
by UL Listed/CSA Certified Power Unit marked "Class 2" or LPS power
source rated 10-30V minimum 1.5A.
CAUTION: Do not attempt to open or otherwise service any
components in the optics cavity. Opening or servicing any
part of the optics cavity by unauthorized personnel may
violate laser safety regulations.
WEEE STATEMENT
English
For information about the disposal of Waste Electrical and Electronic
Equipment (WEEE), please refer to the website at www.datalogic.com.
Italian
Per informazioni sullo smaltimento delle apparecchiature elettriche ed
elettroniche consultare il sito Web www.datalogic.com.
French
Pour toute information relative à l’élimination des déchets électroniques
(WEEE), veuillez consulter le site internet www.datalogic.com.
German
Informationen zur Entsorgung von Elektro- und Elektronik- Altgeräten
(WEEE) erhalten Sie auf der Webseite www.datalogic.com.
Spanish
Si desea información acerca de los procedimientos para el desecho de los
residuos del equipo eléctrico y electrónico (WEEE), visite la página Web
www.datalogic.com.
Portuguese
Para informações sobre a disposição de Sucatagem de Equipamentos
Elétricos e Eletrônicos (WEEE -Waste Electrical and Electronic
Equipment), consultar o site web www.datalogic.com.
Chinese
有关处理废弃电气电子设备 ( WEEE) 的信息， 请参考 Datalogic 公司的网
站 www.datalogic.com 。
Japanese
廃電気電子機器 (WEEE)の処理についての関連事項は Datalogic の
サイト www.datalogic.com をご参照下さい。
European Declaration of Conformity
Hereby, Datalogic S.r.l. declares that the full text of the European Decla-
ration of Conformity is available at: www.datalogic.com. Select the Sup-
port & Service > Downloads > Product Certifications link where you can
search for your specific product certification.
UKCA Declaration of Conformity
Hereby, Datalogic S.r.l. declares that the full text of the UKCA Declaration
of Conformity is available at: www.datalogic.com. Select the Support &
Service >Downloads > Product Certifications link where you can search
for your specific product certification.
Waste Electrical and Electronic Equipment (WEEE) State-
ment
CHINA ROHS TABLE OF RESTRICTED ELEMENTS
ݹᆖ㓴Ԧ
᭷ẘ᭷ᐖ≀峐ᡈඖ⣲
PART
摭
Lead (Pb)
ợ
Mercury
(Hg)
擱
Cadmium
(Cd)
භ௴撔
Hexavalent
Chromium (Cr(VI)
ከ㹜俼劗
Polybrominated biphenyls
(PBB)
ከ㹜Ḵ劗慂
Polybrominated diphenyl
ethers (PBDE)
Cable ⭥㔶
XO O O O O
Printed
Circuit Board
Assy
⭥䐟ᶯ㓴
X O O O O O
Assembly, Module
ݹᆖ㓴Ԧ X O O O O O
Power Supply
⭥※X O O O O O
ᵜ㺘Ṭ׍ᦞ 6-7 Ⲵ㿴ᇊ㕆ࡦDŽ ƻ 㺘⽪䈕ᴹᇣ⢙䍘൘䈕䜘Ԧᡰᴹ൷䍘ᶀᯉѝⲴ䟿൷൘ *%7 㿴ᇊⲴ䲀䟿㾱≲ԕлDŽ h 㺘⽪䈕ᴹᇣ⢙䍘㠣ቁ൘䈕䜘ԦⲴḀа൷䍘ᶀᯉѝⲴ䟿䎵ࠪ *%7 㿴ᇊⲴ䲀䟿㾱≲DŽ
EFUP determined by “Look-up Method” (scanner).ġġ䍗ᾅἧ䓐㛇旸⍾⅛Ḷ“㞍堐㱽”㸦㈓㍷Ẓ炸