Dawson PA200 User manual

Congratulations for your excellent choice on our new electric tool which is
compliance with the best and reliable standards,ensuring you efficiency and
safety for a long period of time
GENERAL SAFETY RULES
WARNING! Before using this electric tool. Carefully read the general safety rules
listed below.
1. Your sockets must comply with safety rules. In case your sockets are not
suitable, it should be checked by a skilled electrician.
2. Your sockets plug must absolutely be grounded and your electric system must
be supplied with a magneto cut out safety.
--When the machine is running unattended, be careful that children cannot reach
it.
--Do not pull the electric cable to disconnect the plug.
--The machine shall be protected from frost and low temperatures.
3. In case the machine cannot hoist a load,do not keep pressing the hoisting
Push button, this means that the load exceeds the machine maximum capacity.
--The machine shall not be disassembled when running or connected to power.
--Do not stand under hoisted weights.
4. Before starting the work, make sure that the steel cable is correctly winded
around the reel and the pitch is equal to the cable diameter.
5. Observe the maximum load indicated on the hoist.not that no the hook!
6. Leave at least three tums of cable around the reel,so that the cable connection
is not under stress.
--To avoid any danger, do not wind more than 15 m of cable around the reel
7. In case the steel cable is worn,it must be replaced only with a cable of
same features manufactured by us. If can be found at all authorized service
shops.
8. In case the hoist stops during the lowering of a load,it is normal that the load
goes down a few centimeters more because of inertia.
9. Attention! The hoist electric motor isn't equip with any overload cut-out(to
avoid an unexpected and unwanted restart)therefore,if you are unable to hoist a
load do not insist and let the motor cool down.
Specification
Method of
use
Rated
volt
(v)
Input
power
(W)
Rate lifting
Weight(KG)
Lifting
speed
(m/min)
Lifting
height
(m)
Quan
tity
(PCS)
Size
(cm)
GW./NW.
(KG)
PA200
Single-hook
110/220
510
100
10
12
1
38*15*24
10/9.5
Double-hook
200
5
6
PA300
Single-hook
110/220
650
150
10
12
1
38*15*24
11/10
Double-hook
300
5
6
PA400
Single-hook
110/220
850
200
10
12
1
44*15*25
15/14
Double-hook
400
5
6
PA500
Single-hook
110/220
1050
250
10
12
1
44*15*25
15.5/14.5
Double-hook
500
5
6
PA600
Single-hook
110/220
1200
300
10
12
1
44*15*25
16/15
Double-hook
600
5
6
P800
Single-hook
110/220
1450
400
10
12
1
44*15*25
17/16
Double-hook
800
5
6
PA1000
Single-hook
110/220
1600
500
10
12
1
53*24*35
28/27
Double-hook
1000
5
6
PA1200
Single-hook
110/220
1800
600
10
12
1
53*24*35
30/29
Double-hook
1200
5
6

MAINTENACE
-- Periodically check that the steel cable is in good conditions.
1. Check that the screws securing the brackets and reduction gear are well
tightened.
2. Check the conditions and tightening of the nuts securing the steel cable
clamp.
3. Regularly check whether the motor stop switch and button switch are in
good working condition.
MICRO ELECTRIC ROPE HOIST
INSTRUCTIONS