DayStar KU81001BK User manual

KU81001BK Hands Free Phone Grip™
KU81001 BK [e-mail] 800-595-7659 © 2019 Daystar Products International
INS81001 v 5 Page 1
Bill of Materials
Part
Description Quantity
M22736
Foam Cup Holder
1
P21618
Slim Grip Cell Phone Holder
1
P21229
Bag with Holder Clip and Ring
1
Verify all the items are present
from the Bill of Materials.
Using the assortment of “arms”
insert the desired arm length into
the ends of the slim grip holder.
841 South 71st Avenue, Phoenix, AZ 85043
623-907-0081
www.daystarweb.com
Insert the tabs in the back of the
slim grip holder and firmly snap
into place to lock in mount
Using the supplied rubber plugs,
insert into the 4 corners of the
slim grip holder.
Correctly mounted assembly.

Insert the threaded ring over the ball
on the arm before clipping in the slip
grip holder. With slight pressure, press
the threaded socket onto the sphere.
With the threaded ring firmly
fastened to the foam cup mount, you
are ready to install to your vehicle.
Note: Slip grip holder is spring
loaded for multi height device use.
Press the Phone grip firmly into place to seat the
foam base into the desired location.
You are now ready to use your Hands Free
Phone Grip!
For different viewing positions, simply loosen the
threaded ring to allow phone cradle adjustment.
Once you are happy with the angle, re-tighten
the ring for a stationary placement.
NOTE: Some cupholders may be too shallow to
fully seat the Phone Grip, Trimming the foam base
may be necessary for best fit. A common serrated
knife will neatly trim the tapered foam base.
Carefully trim until you’re satisfied with the fit.
Locate the ring, slim grip holder
and foam grip assembly.
KU81001 BK [e-mail] 800-595-7659 © 2019 Daystar Products International
INS81001 v 5 Page 2