DB Research DB Link DBLBT1 User manual

DBLBT1
BLUETOOTH CONTROL MODULE
DB Link is a Registered Trademark of
DB Research L.L.P.
Designed and Engineered in the U.S.A.
www.dblink.net
Contact us at: 1-800-787-0101
[e-mail]

The DBLBT1 is an easy to operate
Bluetooth Volume Control Knob.
One simple knob controls all
Bluetooth functions as well as the
system volume!
Red Wire 12v +
Wire to 12v positive (+)
switched ignition or dash
switch
Blue Wire 12v +
Wire to amp remote
turn on input
Black Wire 12v Ground
Negative (-) ground
terminal or ground
terminal block
RCA Cables
RCA inputs on amp
AUDIO PLAY : Start your media player or
music streaming.
AUDIO PAUSE: Tap the knob once to pause,
tap a second time to resume play mode.
TRACK FORWARD: Turn the knob
counter-clockwise for approximately 1
second.
VOLUME UP: Turn and hold the knob
Clockwise to desired volume level.
VOLUME UP: Turn and hold the knob
Counter-clockwise to desired volume level.
HOW TO PAIR THE DBLBT1 TO YOUR BLUETOOTH DEVICE
STEP 1 : Turn on DBLBT1 by turning on your 12 volt ignition or dash switch.
The blue LED will indicate that the DBLBT1 is powered on.
STEP 2: Press in and hold the control knob until you see the blue indicator
ashing. Once ashing, the DBLBT1 is ready to be paired with your
Bluetooth device.
STEP 3: From your device’s Bluetooth pairing menu, nd the DB Link BT
and connect to it.
CONTROL KNOB OPERATING INSTRUCTIONS
UNDER DASH MOUNT
Use two included screws to mount controller under the dash on surface mount
applications using the supplied bracket.
Notice: This unit is universal . Professional installation is highly recommended to ensure proper t and performance. In no
event shall DB Research LLP be liable for any direct, indirect, punitive, incidental, special consequential damages, to property
or life, whatsoever arising out of or connected with the use or misuse of our products.”
MOUNTING INSTRUCTIONS
Remove the surface mount portion of the controller by unscrewing the large nut
on the DBLBT1 back section. Drill a 1” or 25mm hole in your desired mounting
location making sure that you have checked your wires or anything else that could
be aected by the drilling into the dash. Install the controller from the front and
secure it with the main body nut from behind. Make sure the Bluetooth knob is
correctly oriented before tightening into place.
WIRING INSTRUCTIONS DB LINK DBLBT1 BLUETOOTH CONTROL
NOTE: To power unit on and o manually - simply push in and hold the
knob until the unit powers on or o.