www.dbtechnologies.com info@dbtechnologies-aeb.com
S115 420120357Q RE . 1.0
Technical Data
Speaker Type: professional subwoofer
Acoustical Data
Usable Bandwidth [-6dB]:
Freq. response -10 dB): 36 Hz – user freq LFP)
Freq. response -6 dB): 40 Hz – user freq LFP)
MAX SPL @1m) : 134 dB
LF Transducer: 15” neodymium V.C: 4”)
Amplifier
Amplifier technology: Digipro G3
Amp Class: Class-D
RMS Power: 900 W
Peak Power: 1800 W
Cooling:
Operating voltage: 100-240V~ (50-60 Hz) FULL RANGE
Processor and user interface
Controller: 96 kHz processing DSP
Limiter: Peak, thermal, RMS
Controls: Sub attenuation, Sub parameters
Rotary presets: 3 10 positions)
AD/DA Conversion: 24 bit - 96 kHz
Input / Output
Mains: PowerCON TRUE1 IN/LINK
Signal Inputs: 1 x balanced XLR connector
Signal Out/Link: 1 x balanced XLR connector
RDNET connectors: yes
USB connector: mini USB B-type for SERVICE DATA)
Mechanics
Housing: Wooden Box
Grille: Full metal grille
Handles: 2x
Pole mount: 2x
Rigging point: 16 x M10
Width: 650 mm 25.6 in)
Height: 420 mm 16.5 in)
Depth: 550 mm 21.7 in)
Weight: 32.8 kg 72.3 lbs)
EMI CLASSIFICATION
According to the standards EN 55 03 this equipment is designed and suitable to operate in E3 (or lower E2, E ) Electromagnetic environments.
FCC CLASS B STATEMENT ACCORDING TO TITLE 47, PART 15, SUBPART B, §15.105
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 5 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
WARNING: Make sure that the loudspeaker is securely installed in a stable position to avoid any injuries or damages to persons or properties.
For safety reasons do not place one loudspeaker on top of another without proper fastening systems. Before hanging the loudspeaker check
all the components for damages, deformations, missing or damaged parts that may compromise safety during installation. If you use the
loudspeakers outdoor avoid spots exposed to bad weather conditions.
Contact dB Technologies for accessories to be used with speakers. dBTechnologies will not accept any responsibility for damages caused by
inappropriate accessories or additional devices.
Features, specification and appearance of products are subject to change without notice.
dBTechnologies reserves the right to make changes or improvements in design or manufacturing without assuming any obligation to change
or improve products previously manufactured.
Features, specification and appearance of products are subject to change without notice.dBTechnologies reserves the right to make
changes or improvements in design or manufacturing without assuming any obligation to change or improve products previously
manufactured.
Download the complete user manual from the site:
www.dbtechnologies.com/EN/Downloads.aspx
19 W
