Delmhorst Navigator Series User manual

Copyright 2021 Delmhorst Instrument Co.
Navigator Series
TM
Delmhorst
EDGETM App*
Download the App
Support and FAQ
*Navigator Series –
“30” models only
510QSG-0001, Rev 02/2022
Upload readings from meter to app
Access to expanded material/species selections,
including foreign species sets (applicable
meters only)
View all readings on a single screen
Add timestamp and geotags to readings
Exclude outlier readings from statistics
Generates plot of all readings
Customize LED range
Multi-language support for app and meter
Export readings to Excel®for additional
analysis and report generation
51 Indian Lane East
Towaco, NJ 07082
[email protected]
877-DELMHORST (335-6467)
Meter Features
Quick Start
Turn Meter On and Off
Remove tab from inside battery compartment
Press any key to wake meter
Long press center button to initiate timeout
Press Read button from any screen to enter
live reading mode
Read button toggles between held
and live reading
Held readings will blink
Press center button to save reading
from live or held reading
Saved readings will export to EDGETM app
when app and meter are connected*
Take a Reading
Hold a Reading
Save and Export a Reading
Bluetooth®app for customizing device
and exporting data*
English, Spanish, French, German, Italian
and Russian*
Customizable*, color-coded LED’s
Built in material, temperature and
pin-type correction
Adjustable alarm
Built in calibration check
Compatible with all Delmhorst electrodes
Powered by 2 x AA batteries
2 year warranty
Quick Start Guide

View, hold and save readings
Change material/species
Adjust alarm set point
Set material temperature (applicable meters only)
Set insulated vs. non-insulated pins
(applicable meters only)
READ
Save up to 100 readings
Saved readings contain material type,
reading value, material temp, and pin type
View average, high and low values
View last 10 readings
STATS
Calibration Check: 12.0 +/- 0.2
Temperature Units: °F/°C
Meter Timeout: 1/4/10 minutes
Bluetooth®: ON/OFF
Display Brightness: 1-10
Backlight: ON/OFF/AUTO
Display Contrast: 1-10
SET
Your MeterComponents
1) Display
Large, easy to read under all conditions
2) Read Button
Press from any screen to enter live
reading mode
Press again to toggle between live
and held reading
3) Navigation Buttons
Move between and down into the
READ, SET and STATS menus
Center button to save readings
or changes to settings
4) Easy-grip Handle
Easily push pins into material
5) Colored LEDs
Red, yellow, and green LEDs show the
relative moisture status
Adjustable within the Delmhorst EDGETM App
6) Ambient Light Sensor
Turns backlight on and off in Auto
Backlight mode
7) Pins (applicable meters only)
Insert integral pins up to 5/16” into material
to take reading
8) Electrode Connector
Connect with any Delmhorst
electrode to extend functionality
Display
Read Button
Navigation
Buttons
Pins &
Pin Cap
Light
Sensor
7
LEDs
Electrode Connector
& Electrode Cap
Easy-grip
Handle
Bluetooth®Indicator *
• Solid
- On and connected
• Blinking
- On and seeking connection
• None
- Off
Read Adjustments
Up/down to move between
Read screen settings
Left/right buttons to
adjust value
Selection Arrows
Left/right to adjust
when blinking
Center/down to enter
current selection
1
2
3
4
5
6
7
8
6
5
8
1
2
3
4