DeLonghi N/A User manual

instructions
Automatic Filter
Coffee Maker
ICM07 30-12-2002 14:42 Pagina 1

Coffee Maker 2
Water reservoir lid
Stainless steel mug
ON button
with light indicator
Suspended filter holder
Water
reservoi
r
Permanent filter
ICM07 30-12-2002 14:42 Pagina 2

Thank you for choosing this De’Longhi coffee maker.To get
the best results from your new coffee maker it is advisable to
read these instructions carefully before using the appliance.
This is the only way to ensure optimum results and maximum
safety.
Using for the first time
Carefully unpack the coffee maker and remove all the packaging
material. Before using wash the mug and surfaces. Do not
immerse the coffee maker in water; simply wipe with a cloth and
mild detergent if necessary. Do not put in the dishwasher or use
harsh, abrasive cleaners.
For the best tasting results prior to making coffee we recommend
that you flush the coffee maker out with cold water only, without
using coffee to remove any dust which may still be inside the cof-
fee maker. To do this follow the directions ‘Preparing the coffee’.
Installation
• Place the coffee maker on a flat work surface at a safe distance
from taps and sinks.
• Check that the voltage corresponds to that indicated on the
appliance rating plate.The appliance must always be connected
to a well-earthed socket rated at 10A minimum.The manufac-
turer is not liable for damage caused by inadequate earthing of
the appliance.
• In the event of incompatibility between the plug on the appli-
ance and the socket, have the plug replaced by a qualified serv-
ice engineer.
If the cable is damaged or requires replacing, contact a service
centre authorised by the manufacturer only.
• Never install the machine in an environment that can reach a
temperature less than or equal to 0°C (the appliance may be
damaged if the water freezes).
•N.B.:This coffee maker has an on button instead of a switch.
Coffee Maker
3
ICM07 30-12-2002 14:42 Pagina 3

Preparing the coffee
1. Fill the mug with cold water from the tap.
2. Lift the water reservoir lid and pour the water into the reser-
voir.
3. Place the permanent filter into the filter holder and place
ground coffee into the filter (approx 7grms). Close the lid.
4. Place the mug underneath the filter holder and plug in the appli-
ance.
5. Press the on button, the indicator light will come on.
6. The coffee will start to filter through.
7. When there is no more water left in the reservoir, the coffee
maker will switch off automatically.
8. Wait about three minutes before removing the mug to allow
the coffee to finish filtering.
Cleaning and maintenance
•Before cleaning or maintenance always turn the appliance off,
unplug from the mains socket and leave to cool
•When cleaning the appliance and tray use a soft, damp cloth; do
not use solvents or abrasive detergents
•The mug and filter holder can be washed in the dishwasher
•Never emerge the appliance in water
Descaling
Over time, calcium in the water may build up and cause blockages
reducing the efficiency of the coffee machine and increasing the
time required to make coffee. To obtain optimum performance,
the appliance should be descaled regularly.
•Using equal parts of water and vinegar pour the solution into
the water reservoir and switch on the appliance.
•When the solution has flowed through, repeat again twice more
using water only to rinse the appliance thoroughly.
Coffee Maker 4
ICM07 30-12-2002 14:42 Pagina 4

Coffee Maker
5
Safety Warnings
•This appliance is designed to make coffee.Take care during use to
avoid burns caused by the water or steam jets or improper use of
the appliance.
•When the appliance is in use, do not touch any of the machine’s hot
surfaces.
•After unpacking, make sure that the machine is complete and
undamaged. In case of doubt, do not use and seek the advice of a
qualified service professional.
• Packaging materials (plastic bags, foam polystyrene, etc.) should not
be left within the reach of children as this could be a potential
source of danger.
•This appliance is to be used for domestic use only. Any other use is
to be considered improper and therefore, dangerous.
•The manufacturer takes no responsibility for damage derived from
improper use.
•The use of an accessory not recommended for use with this appli-
ance may cause injuries.
•Never use warm or hot water to fill the water reservoir, use cold
water only.
•Never lift the lid during the brewing cycle as this may cause scalding.
•Never touch the appliance with wet or damp hands.
•Never allow the appliance to be used by children or unfit persons.
•Do not allow children to play with the appliance.
•In the event of breakdown or malfunctioning, turn the appliance off
immediately and do not touch. For repairs, please contact a Service
Centre authorized by the manufacturer failure to observe the above
points may affect the safety of the appliance.
•The power cable must never be replaced by the user. If the cable
should become damaged, or needs to be replaced, please contact a
Service Centre authorized by the manufacturer.
•When the appliance is not in use, turn off and disconnect the plug
from the socket.
•As with any electrical appliance, whilst the instructions aim to cover
as many eventualities as possible, caution and common sense should
be applied when operating your appliance, particularly in the vicinity
of young children.
Power cord
A short power cord is provided to reduce the hazards resulting
from entanglement or tripping over a longer cord.
An extension cord may be used with care; however, ensure the
marked electrical rating is at least as great as the rating of this
appliance.
The extension cord should be positioned so it does not drape
over the counter or tabletop where it can be pulled by children or
tripped over.The electrical rating of this appliance is listed on the
bottom panel of the appliance.
ICM07 30-12-2002 14:42 Pagina 5

Coffee Maker 6
Electrical requirements
Before using this appliance ensure that the voltage indicated
on the product corresponds with the main voltage in your
home, if you are in any doubt about your supply contact your
local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity. Should this plug not fit the socket out-
lets in your home, it should be cut off and replaced with a suitable plug,
following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of and not left where children might find
it and plug it into a supply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that
can be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter E or by the earth
symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely
retained in each terminal. Do not forget to tighten the mains lead clamp
on the plug. If your electricity supply point has only two pin socket out-
lets, or if you are in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be refitted.
If the fuse cover is lost, the plug must not be used until a replacement
cover is obtained.The colour of the correct replacement fuse cover is
that of the coloured insert in the base of the fuse recess or elsewhere
on the plug. Always state this colour when ordering a replacement fuse
cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362
should be fitted.
This appliance conforms to the Norms EN 55014 regarding the sup-
pression of radio interference.
Warning - this appliance must be earthed
GREEN ANDYELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
Green and Yellow to Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord Clamp
ICM07 30-12-2002 14:42 Pagina 6

139IDL/09.02
ICM07 30-12-2002 14:42 Pagina 7