2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce risk
of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use
handle when moving this heater. Keep combustible materials, such as furniture, pillows,
bedding,papers,clothes,andcurtainsatleast3feet(0,9m)fromthefrontandtopoftheheater
and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Donotoperateanyheaterwithadamagedcordorplugoraftertheheatermalfunctions,
has been dropped or damaged in any manner. Return heater to authorized service
facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. Thisheaterisnotintendedforuseinbathrooms,laundryareasandsimilar indoorlocations.
Never locate heater where it may fall into a bathtub or other water container.
8. Donotruncordundercarpeting.Donotcovercordwiththrowrugs,runners,orthelike.
Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Connect to properly polarized outlets only.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause an electric shock, fire, or damage the heater.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
13. A heater has hot or arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
14. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
15. Topreventoverloadandblownfuses,besurethatnootherapplianceis pluggedintothesame
outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
16. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which
becomes hot to the touch or becomes distorted in shape may be a result of a worn electrical
outlet (receptacle). Worn outlets or receptacles should be replaced prior to further use of the