DELTA DORE Tywatt EM.IC User manual

EM.IC
EN
Consumption information transmitter
for double-service heat pump

2 3
EN
1 - Installation
Install the EM.IC around 1.50 m off the ground.
2 - Mounting - connection
- Switch off the installation power supply
- Install the device around 1.50 m off the ground
to enhance radio propagation.
- Connect the power supply to terminals 1 and 2.
- To select the cabling suitable for your installation,
consult the specications contained
in the assembly instructions or in the specications
provided by the manufacturer of your heat pump
You can nd installation diagrams adapted
to your heat pump on the EM.IC page of
the www.deltadore.com site
1,50 m
Heat pump
20 cm 1
4
5
230V~
50 Hz
OFF
2
3
7
230V~
50 Hz
ON
6
!
1 2 3
L
L
N
230V ~
50 Hz
...

4 5
EN
3 - Pairing with an RT2012 system manager 4 - Pairing with the Tydom app
Your installation is equipped with a Tywatt
5400/5450, which is already paired with the
Tydom application - pair the EM.IC with the Tydom
application.
From the Tydom application, select
Settings > My home > My devices > Add a device >
Consumption > then select your previously paired
Tywatt with which you wish to pair the EM.IC and
follow the on-screen instructions.
OK
1
5
>3s
2 43
... ... ... .. .. ..... .. ..
6
OFF
OK
5 6
>3s
21 43
OFF
... ... ... .. .. ..... .. ..
Set the
system manager
to pending pairing.
Read the instructions
- Hold down the button for 3 seconds
until the LED ashes, then release.
- Briey press the button, the LED will ash quickly.
- Hold down the button for 3 seconds
until the LED ashes, then release.
- Briey press the button, the LED will ash quickly.
Check on the system ma-
nager that the pairing
was successful
Check that the LED on the EM.IC
is no longer ashing.
The products are now paired.

6 7
EN
5 - Reset to factory settings
❶Hold down the receiver button for 10 seconds:
- after 3 seconds, the LED ashes slowly.
- after 7 seconds, the LED ashes quickly.
- press and hold the button until the LED goes
out.
❷Release.
All paired devices are now deleted.
RESET OK
12
>10s
3s 7s
... ... ...
OFF
.. .. ..... .. ..
Technical specications
- Power supply: 230 V~, 50 Hz,
- Consumption : 1 VA
- Class II insulation
- Type 1 action
- Rated impulse withstand voltage: 2500 V
- Ball test temperature: 75°C
- Storage temperature: -10°C / +70°C
- Operating temperature: 0°C / +55°C
- IP 44 with the supplied cable.
Vertical positioning of the product
- Dimensions: 54 x 140 x 25 mm
- X3D wireless remote control device:
868.7 MHz to 869.2 MHz
- Maximum wireless power < 10 mW
- Category 2 receiver
- Installation in an environment with normal pollution
levels
- Cable: 3 x 0.75 mm2(type H05VV-F)
Min. diameter: 6.5 mm.
Length: 1 m.
If the EM.IC is paired with the Tydom application,
begin by deleting the pairing via the Tydom
application.

03/23
www.deltadore.com