Delta HDRS6800 User manual

x1 — Top Connector
x2 — Top Pole
x2 — Center Pole
x2 — Bottom Pole
x2 — Base Stand (Left + Right)
x1 — Base Bracket
x4 — Long Bolts
x8 — Arms
x4 — Short Bolts
x2 — Extra Long Bolts
x2 — Nuts (10mm)
x2 — Washers
x4 — O Ring
Parts
A
B
C
D
E
F
G
H
I
J
K
K
L
M
Assembly instructions HDRS6800
WARNING
DO NOT EXCEED MAXIMUM TOTAL WEIGHT LIMIT OF 160 LBS (70 Kgs)
MAX LOAD PER HOOK: 35 LBS (15.9 kgs) / MAX WEIGHT PER BIKE: 40LBS (18.2 kgs)
LOAD HEAVIER BIKES, INCLUDING EBIKES, ON LOWER TIER.
C
H
D
A
K
F
E
L
I
G
Four Bike
Free-Standing
Rack
B
Assembly Video
Visit designbydelta.com/downloads
Scan with your smartphone camera to view
C
H
D
A
F
F
ME
I
I
J
G
Tool(s) Required
Phillips Head
Screwdriver
Adjustable Wrench
(or 10mm)

1Connect base bracket (F), bottom poles (D) and base stand (E)
as shown using long bolts (G, J) Nuts (K) and Washers (L).
Do not tighten bolts until rack is fully assembled and tubes are
properly aligned. Fully assemble base before continuing.
3
5
Connect top poles (B)
to center poles (C),
secure with short bolts (I).
Connect top connector (A)
to top poles (B) using
long bolts (G).
4
2Connect center poles (C) to bottom poles (D),
secure with short bolts (I).
Adjust position of arms before
placing bike on stand.
Tighten all bolts, using
the wrench to hold nuts
where needed.
O Rings (M) are included
toto slide over the base
legs to ensure balance
on uneven oors (Figure 1)
IMPORTANT / SAFETY
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
© Copyright 2020
After rack is assembled
Arms should be placed at
desired height - two per
bike (front and rear).
Front side of rack features the
longer section of the base foot
Need help? Please do not return to store.
For immediate response email [e-mail]
Always load bikes on the arms of the bottom,
front side of the rack rst to maintain stability.
Remove bikes from the top rst.
Ebike storage on lower tier only.
Do not allow children to play or hang from rack.
FIGURE 1