Delta RS8700 User manual

x1 — Wheel Holder Assembly
x2 — Base Legs
x4 — Bolts M5 (pre installed)
x4 — Rubber Feet (pre installed)
Tool Required
Parts
Phillips Head
Screwdriver
A
B
C
D
B
A
C
D
Assembly instructions RS8700
Adjustable Spring
Floor Stand

Works with most tire widths
For tires wider than 4.5 inches
“CLICK”
“CLICK”
TO CLOSE
CAUTION
2IMPORTANT
SAFETY NOTE
Be careful of ngers when
releasing wheel holder spring.
Delta Cycle Corporation 36 York Avenue, Randolph, MA 02368 USA / 800-474-6615 / www.designbydelta.com
Need help?
Email us at [e-mail]
& we’ll help solve your issue.
Assembly video
Visit designbydelta.com/adjustable_spring_oor_stand
1
3To adjust for widest tires:
Disassemble rotating wheel guide & reposition ridged spacers as shown.
Take care to replace all washers in correct position.
Do not over tighten bolts; allow wheel guides to rotate in place.
Unfold rack by raising wheel holder arms.
It will click into position when ready to hold
front or rear wheel.
To close: Push release button to gently
lower the wheel holder – careful of ngers!
Mount legs to the wheel holder assembly.
Tighten bolts with screwdriver.