Demco magstak User manual

Remove items from packaging and check for proper contents
and quantity.
2S sign (2 pieces)
rubber pad (4)
spinner base bottom
magstakTM module x 2
spinner base (1)
1
See optional magstakTM signage assembly instruction on
reverse/page 2.
5
Attach rubber pads on metal plate on the bottom of the
spinner base using the smallest holes as placement markers.
Stack one magstak™ module on top of the spinner base
using the alignment disks that set into alignment ports
as shown below.
2
3
magstakTM counter display
assembly instructions
optional
4S sign (2 pieces)
detail 1
connector bolt
detail 2
binding post
connector bolt
module
black spinner
base
binding post
module
module
neoprene washer
binding post screw
Optional: connect bottom module to spinner base
using connector bolts (see detail 1). Stack second
module in same fashion and connect the two modules
using the binding post, neoprene washer and binding
screw (see detail 2) to ensure a secure and stable fit.
Do not over tighten!
4
Find magstak products @demco.com
Search:
magbox
Call 800.962.4463 or email [email protected]

You can use one standard 8.5 x 11 inch piece of paper to
satisfy all of your signage needs. See options below.
2S signage
for 2S signage for 4S signage
4S signage
Insert your printed signage into appropriate holder
as shown below.
2
1
2S signage 4S signage
Combine signage components.
3
2S signage 4S signage
Place signage on top-most magstakTM module, making
sure to connect alignment discs with alignment ports.
4
8.5 x 11 inch
Letter Paper
8.5 x 5.5 in
8.5 x 2.75 in
optional magstakTM signage
assembly instructions
Find magstak products @demco.com
Search:
magbox
Call 800.962.4463 or email [email protected]