Denon AVR-4806CI User manual

AVR-4806CI
A/V Surround Receiver
THX Ultra2 Certified 7.1-channel A/V Surround Receiver
Denon’s AVR-4806CI has technology, the reference sound quality and an extensive feature set, that previously was only available on its
critically acclaimed sibling, the AVR-5805. But it also stands alone with the introduction of some exciting new technologies, not found on
any previously released Denon receivers. The AVR-4806CI is the first product from Denon to offer XM Satellite Radio Ready ‘Connect and
Play’ capability. And for the ultimate in connection flexibility and ease of use, the AVR-4806CI is the first A/V receiver to offer Analog Video
to digital HDMI output conversion, which allows all video sources input through the AVR-4806CI to be output on one HDMI cable.
The highly regarded Audyssey MultEq setup system is included, to give more realism and higher sound reproduction to any environment
the AVR-4806CI may be installed. Denon original technologies are present as well, DDSC-Digital, AL24 Processing Plus and the latest
Denon Link 3rd digital interface.
Moreover, AVR-4806CI is equipped with various network functions such as internet radio, audio streaming and A/V amplifier network
Setup.
Audio Section
■ THX Ultra2 Certified 7-channel High Power Amplifier
Front 140 W + 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
Center 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
Surround 140 W + 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
Surround back 140 W + 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
The AVR-4806CI proudly bears the THX Ultra2 logo, certifying that it satisfies the
strict standards of Lucasfilm, Inc., governing performance, features, sound quality,
power, stability into low-impedance speaker loads (3.2 ohms and higher), and ease of
operation.
■ 'New DDSC-Digital,' for dramatically improved processing performance
The New DDSC (Dynamic Discrete Surround Circuit)- Digital is a high-quality
surround sound reproduction circuit designed by Denon, and forms the core of the
design concept that Denon pursues for all its A/V amps: to faithfully reproduce the
original intent of content producers. Denon has succeeded in developing a fully dis-
crete design for the New DDSC-Digital in which high-performance ICs are used in
independent blocks to form a signal processor that reproduces surround sound, and
the discrete design ensures that all channels are endowed with identical response
and quality of sound.
■ New 32-bit floating point DSP
Three of the latest 32-bit floating point DSPs for the decoder.
• 24-bit/192-kHz D/A Converter
The latest high-accuracy 24-bit/192-kHz D/A converter has been employed
for the audio DAC.
• High-performance A/D Converter
A high-performance A/D converter of 24-bit/192-kHz quality has been used
to significantly boost S/N and dynamic range.
■ 'AL24 Processing Plus,' for high sound quality
■ DENON Link, enabling high-speed, high-grade digital signal transmission
■ IEEE 1394 digital interface
■ Large-output Power Amp Section and Power Supply Configuration,
for stable high-power output
■ Stabilized, independent power supplies for each circuit
■ Chassis construction to suppress internal/external vibration
■ Pure Direct mode, for the pure enjoyment of music in high-quality sound
■ Configurable Center, Surround and Surround Back Amplifiers
• Multi-zone system: a 5.1-channel theater in the main room and a monaural
environment in a second and third rooms.
• "Bi-amp" system: Front (L/R) channels are bi-wired in a 5.1-channel theater to
improve playback quality in the front for enhanced listening enjoyment.
■ Pre-amp with Variable Gain Volume
■ New Auto Set-up and Room EQ, featuring MultEQ from
Audyssey, for overall listening area support using supplied
microphone
■ Full support for the most advanced surround playback formats
• Dolby Digital EX • Dolby Digital • Dolby Pro Logic IIx
• Dolby Headphone • DTS-ES • DTS 96/24 • DTS Neo:6 • DTS • HDCD
■ THX, THX Surround EX, THX Ultra2 Post Processing Modes
■ Original surround modes from Denon
■ XM Satellite Radio Ready with optional XM Passport System*
*Subsciption to XM services also required.
Video Section
■ Video Up/Down Conversion capable of output to HDMI port
The AVR-4806CI includes a video up/down conversion function that allows the unit
to be connected to the video monitor via a single cable regardless of the video input
signal's format as follows:
1) Composite video signals are converted to HDMI (*1), component video, & S-video;
2) S-video signals are converted to HDMI (*1), component video, & composite video;
3) Component video signals are converted to HDMI (*1), composite video (*2), & S-video (*2).
*1. Output signal up-converted to HDMI retains the resolution of the input signal.
*2. Down-conversion from component video to composite or S-video applies only to 480i input signals.
■ 1080p upscaling
■ Component video switching
The AVR-4806CI is equipped with 3 sets of component video inputs. There are also
2 sets of component video outputs capable of simultaneous output, allowing compo-
nent video with high picture quality to be enjoyed on two monitors at the same time.
Settings do not need to be changed each time a monitor is switched. These component
video circuits achieve sharp HDTV video quality in a frequency range up to 100 MHz.
■ High-speed, high-accuracy 12-bit/216-MHz Video DAC
A high-speed, high-accuracy 12-bit/216-MHz video DAC is used in the video circuitry
for component video, S-video, and composite video signals. This DAC enhances the
reproducibility of delicate-level video signals, allowing high-definition video to be
played back with greater fidelity to the original images. In addition, noise shaped
video (NSV) technology improves video S/N for greater signal linearity.
■ Composite and S-video signal processing
The AVR-4806CI uses a time base corrector (TBC) in converting composite video & S-
video signals to component video to suppress jitter in the video signal during playback.
Expandability
■ Analog EXT IN terminal
■ 3 Source and Zone Capability
■ Ethernet and RS-232C terminals, for external 3rd party control system
The AVR-4806CI’s Ethernet and RS-232C ports provide support for serial control
using AMX, Crestron and others.
AVR4806CI_E3.qxd 06.6.26 6:57 PM Page 1

Other Functions
■ Internet connectivity
• Audio streaming • Internet radio
• A/V receiver Network Setup (Web control)
■ Auto Surround Back Channels ON function,
for auto-detection of supporting sources
■ Auto Surround mode
■ New design and ease-of-use
• Front panel's large display.
• A cursor key and Buttons on the front panel
■ New EL remote controller with GLO-Key for easy operation
■ On-screen display, for easier, error-free operation
■ Variable subwoofer crossover switching
(40/60/80/90/100/110/120/150/200/250 Hz)
■ Muting level settings (∞/-40dB/-20dB)
■ Audio Delay function (max. 6 frames or 200 msec)
■ 3 User Mode Buttons
Denon Canada Inc.
505 Apple Creek Blvd, Unit 5, Markham, Ontario, Canada L3R 5B1
TEL: [phone] www.denon.ca
Denon Electronics (USA), LLC.
100 Corporate Drive Mahwah, New Jersey 07430 USA
TEL: [phone] www.usa.denon.com
Denon Brand Company
D&M Building, 2-1 Nisshin-cho, Kawasaki-ku, Kanagawa 210-8569, Japan
www.denon.com
16590606 A
AVR-4806CI
Input/Output Terminals For Every A/V System
Audio Inputs
12 Sets Analog Input
PHONO, CD, TUNER, DVD, VDP, TV, DBS, VCR-1, VCR-2, VCR-3, V.AUX, CDR/TAPE
1 Set 8-ch Analog EXT. Input
FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R, SUBWOOFER
8 Digital Inputs
OPTICAL x 5
COAXIAL x 3
Audio Outputs
1 Set 8-ch Analog PRE Output
FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R, SUBWOOFER
4 Sets Analog REC Output
VCR-1, VCR-2, VCR-3, CDR/TAPE
2 Sets Analog Multi Zone Output
ZONE2 L/R, ZONE3 L/R
3 Digital Outputs
OPTICAL x 3
Video Inputs
1 Set DVI-D Video Input
3 Sets HDMI Video Input (with Digital Audio) 1, 2, 3
3 Sets Component Video Input 1, 2, 3
8 Sets Composite Input
DVD, VDP, TV, DBS, VCR-1, VCR-2, VCR-3, V.AUX
8 Sets S-Video Input
DVD, VDP, TV, DBS, VCR-1, VCR-2, VCR-3, V.AUX
1 Set DVI Input
Video Outputs
1Set HDMI Video Output (with Digital Audio)
MONITOR
2 Set Component Video Output
MONITOR-1, MONITOR-2
4 Sets Composite Output
VCR-1, VCR-2, VCR-3, MONITOR
4 Sets S-Video Output
VCR-1, VCR-2, VCR-3, MONITOR
2 Sets Multi Zone Output
ZONE2 (Composite& S-Video), ZONE3 (Composite& S-Video)
Video/Audio Inputs
3 Sets of HDMI
Video/Audio Outputs
1 Set of HDMI
Specifications
Power Amplifier Section
Rated output *THD figures are power amp stage values.
Front 140 W + 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
165 W + 165 W (6 ohms, 20Hz - 20kHz, 0.05 % THD)
Center 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
165 W (6 ohms, 20Hz - 20kHz, 0.05 % THD)
Surround 140 W + 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
165 W + 165 W (6 ohms, 20Hz - 20kHz, 0.05 % THD)
Surround back
140 W + 140 W (8 ohms, 20Hz - 20kHz, 0.05 % THD)
165 W + 165 W (6 ohms, 20Hz - 20kHz, 0.05 % THD)
Preamplifier Section
Input sensitivity/impedance
PHONO(MM)
2.5 mV/47 kohms
CD, DVD, VDP, TV, DBS, VCR-1, VCR-2, VCR-3, V.AUX, CDR/TAPE,
FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK, SUBWOOFER
200 mV/47 kohms
Output level/Load impedance
FRONT L/R, CENTER, SURROUND L/R, SURROUND BACK L/R, SUBWOOFER,
MULTI ZONE L/R
1.2 V/10 kohms
VCR-1, VCR-2, VCR-3, V.AUX, CDR/TAPE
200 mV/47 kohms
Frequency response 10 Hz - 100 kHz; +0, -3 dB (DIRECT MODE)
Signal-to-noise ratio 102 dB (DIRECT MODE)
RIAA deviation ±1 dB (20 Hz - 20 kHz)
Tone control Treble: ±10 dB at 10 kHz, Bass: ±10 dB at 100 Hz
FM Section
Tuning frequency range 87.5 - 107.9 MHz
Usable sensitivity 1.0 µV (11.2 dBf)
AM Section
Tuning frequency range 520 - 1710 kHz
Usable sensitivity 18 µV
General
Power supply AC 120 V, 60 Hz
Power consumption 10.6A
Dimensions 434 (W) x 178 (H) x 500 (D) mm
17-3/32” (W) x 7-0” (H) x 19-11/16” (D)
Weight 23.8 kg, 52 lbs 8oz
* Design and specifications are subject to change without notice.
* "Dolby", "Dolby Digital-EX", "Pro Logic IIx", and the double-D device are registered trademarks of Dolby Laboratories Licensing Corporation,
* "DTS", "DTS-ES" and "NEO:6" are trademarks of Digital Theater System, Inc.
* HDCD®, High Definition Compatible Digital® and Microsoft® are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.
* "DCDi" is a trademark of Faroudja, a division of Genesis Microchip Inc.
* Audyssey MultEQ is a trademark of Audyssey Laboratories. MultEQ and the Audyssey MultEQ logo are trademarks of Audyssey Laboratories, Inc.
* NSV and Sub Alias Filter are registered trademarks of Analog Devices, Inc.
* ©2006 XM Satellite Radio Inc. All rights reserved.
Inside of the trapdoor
AVR4806CI_E3.qxd 06.6.26 6:57 PM Page 2